On 05/17/2011 07:06 AM, Jason Liu wrote: > Hi, Fabio, > > 2011/5/17 Fabio Estevam <fabio.este...@freescale.com>: >> Make the weim register set complete for MX51/MX53. >> >> While at it also add the weim chip select 1 address definition. >> > > From the code, you just add the cs for mx53 not for mx51, so, > Had better specify you add the cs1 address definition for mx53, > otherwise, it will make confusion.
Sure ? The structure is not protected by any CONFIG_MX5x switch, and at least one mx51 board uses it. The registers have the same layout for both processor. Why do you think is only for MX53 ? Regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
