[PATCH 09/10] net: mediatek: don't enable GDMA cpu bridge unconditionally for NETSYSv3

[Weijie Gao]

Enable GDMA cpu bridge only when 10Gb interface is enabled for GMAC other
than GMAC0, or when MT7988 internal switch is used.

Signed-off-by: Weijie Gao <weijie....@mediatek.com>
---
 drivers/net/mtk_eth.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)

diff --git a/drivers/net/mtk_eth.c b/drivers/net/mtk_eth.c
index d3f29e4a0d0..888e8c1e855 100644
--- a/drivers/net/mtk_eth.c
+++ b/drivers/net/mtk_eth.c
@@ -1762,10 +1762,16 @@ static int mtk_eth_start(struct udevice *dev)
                if (priv->sw == SW_MT7988 && priv->gmac_id == 0) {
                        mtk_gdma_write(priv, priv->gmac_id, GDMA_IG_CTRL_REG,
                                       GDMA_BRIDGE_TO_CPU);
-               }
 
-               mtk_gdma_write(priv, priv->gmac_id, GDMA_EG_CTRL_REG,
-                              GDMA_CPU_BRIDGE_EN);
+                       mtk_gdma_write(priv, priv->gmac_id, GDMA_EG_CTRL_REG,
+                                      GDMA_CPU_BRIDGE_EN);
+               } else if ((priv->phy_interface == PHY_INTERFACE_MODE_USXGMII ||
+                           priv->phy_interface == PHY_INTERFACE_MODE_10GBASER 
||
+                           priv->phy_interface == PHY_INTERFACE_MODE_XGMII) &&
+                          priv->gmac_id != 0) {
+                       mtk_gdma_write(priv, priv->gmac_id, GDMA_EG_CTRL_REG,
+                                      GDMA_CPU_BRIDGE_EN);
+               }
        }
 
        udelay(500);
-- 
2.34.1