Hi, thank you all! This is outstanding, such a fast feedback! As I also just ran a tool over the texts, adjusted formatting and reverted/accepted some changes manually to my knowledge (I'm not a native speaker).
On Tue, Nov 19, 2024 at 11:48 PM Heinrich Schuchardt <xypron.g...@gmx.de> wrote: > > Am 19. November 2024 23:28:36 MEZ schrieb Lothar Rubusch > <l.rubu...@gmail.com>: > >Fix some typos and duplicate words in gdb.rst. [...] > > CONFIG_CC_OPTIMIZE_FOR_DEBUG=y > >@@ -24,8 +24,8 @@ Otherwise build, install, and run U-Boot as usual. > > Using OpenOCD as GDB server > > --------------------------- > > > >-`OpenOCD <https://openocd.org/>`_ is an open source tool supporting hardware > >-debug probes, and providing a GDB server. It is readily available in major > >Linux > >+`OpenOCD <https://openocd.org/>`_ is an open-source tool supporting hardware > >+debug probes and provide a GDB server. It is readily available in major > >Linux > > Thanks for the patch. > > 'tool' is singular. You cannot use 'provide' here. Ok. > > distributions or you can build it from source. > > > > Here is example of starting OpenOCD on Debian using a J-Link adapter and a > >@@ -124,7 +124,7 @@ with the command *bdinfo*: > > Early malloc usage: cd8 / 2000 > > > > Look out for the line starting with *relocaddr* which has the address > >-you need, ``0x27f7a000`` in this case. > >+You need, ``0x27f7a000`` in this case. > > You is only capitalized at the start of sentences. Ok. > > > > On most architectures (not sandbox, x86, Xtensa) the global data pointer is > > stored in a fixed register: > >@@ -144,7 +144,7 @@ riscv gp > > sh r13 > > ============ ======== > > > >-On these architecture the relocation address cat be determined by > >+On this architecture the relocation address can be determined by > > On these architectures ... Ok.
