Am 19. November 2024 23:28:36 MEZ schrieb Lothar Rubusch <l.rubu...@gmail.com>: >Fix some typos and duplicate words in gdb.rst. > >Signed-off-by: Lothar Rubusch <l.rubu...@gmail.com> >--- > doc/develop/gdb.rst | 14 +++++++------- > 1 file changed, 7 insertions(+), 7 deletions(-) > >diff --git a/doc/develop/gdb.rst b/doc/develop/gdb.rst >index 4e359c7f22..dc38435227 100644 >--- a/doc/develop/gdb.rst >+++ b/doc/develop/gdb.rst >@@ -8,12 +8,12 @@ Using a JTAG adapter it is possible to debug a running >U-Boot with GDB. > A common way is to connect a debug adapter to the JTAG connector of your > board, run a GDB server, connect GDB to the GDB server, and use GDB as usual. > >-Similarly QEMU can provide a GDB server. >+Similarly, QEMU can provide a GDB server. > > Preparing build > --------------- > >-Building U-Boot with with reduced optimization (-Og) and without link time >+Building U-Boot with reduced optimization (-Og) and without link time > optimization is recommended for easier debugging:: > > CONFIG_CC_OPTIMIZE_FOR_DEBUG=y >@@ -24,8 +24,8 @@ Otherwise build, install, and run U-Boot as usual. > Using OpenOCD as GDB server > --------------------------- > >-`OpenOCD <https://openocd.org/>`_ is an open source tool supporting hardware >-debug probes, and providing a GDB server. It is readily available in major >Linux >+`OpenOCD <https://openocd.org/>`_ is an open-source tool supporting hardware >+debug probes and provide a GDB server. It is readily available in major Linux
Thanks for the patch. 'tool' is singular. You cannot use 'provide' here. > distributions or you can build it from source. > > Here is example of starting OpenOCD on Debian using a J-Link adapter and a >@@ -124,7 +124,7 @@ with the command *bdinfo*: > Early malloc usage: cd8 / 2000 > > Look out for the line starting with *relocaddr* which has the address >-you need, ``0x27f7a000`` in this case. >+You need, ``0x27f7a000`` in this case. You is only capitalized at the start of sentences. > > On most architectures (not sandbox, x86, Xtensa) the global data pointer is > stored in a fixed register: >@@ -144,7 +144,7 @@ riscv gp > sh r13 > ============ ======== > >-On these architecture the relocation address cat be determined by >+On this architecture the relocation address can be determined by On these architectures ... The rest seems correct. Best regards Heinrich > dereferencing the global data pointer stored in register, *r9* in the example: > > .. code-block:: console >@@ -153,7 +153,7 @@ dereferencing the global data pointer stored in register, >*r9* in the example: > $1 = 0x27f7a000 > > In the GDB shell discard the previously loaded symbol file and add it once >-again with the relocation address like this: >+again, with the relocation address like this: > > .. code-block:: console >
