On 2011/03/18 12:53 PM, Prafulla Wadaskar wrote: >> -----Original Message----- >> From: u-boot-boun...@lists.denx.de [mailto:u-boot-boun...@lists.denx.de] >> On Behalf Of ro...@dawes.za.net >> Sent: Friday, March 18, 2011 1:40 PM >> To: u-boot@lists.denx.de >> Subject: [U-Boot] Non-working Relocated DNS323 config >> >> This patch series contains the previous working configuration for >> the DNS323, forward-ported to mainline, taking into account changes >> made to the EDMiniV2 configuration on which this is based. >> >> Unfortunately, this does not boot at all. I get: >> >> Marvell>> bootm >> ## Booting image at 00100000 ... >> Image Name: UBoot dns323 >> Image Type: ARM U-Boot Kernel Image (uncompressed) >> Data Size: 170100 Bytes = 166.1 kB >> Load Address: 03000000 >> Entry Point: 03000000 >> Verifying Checksum ... OK >> OK >> >> Starting kernel ... > > There might be machine id mismatch in the kernel and programmed in u-boot for > this board. > > Regards.. > Prafulla . .
Hi Prafulla, That log is of me trying to chain load the new U-Boot from the vendor U-Boot. I am not yet ready to try flashing images, because my JTAG adapter has not yet arrived and been proved working :-) What I was expecting to see after the "Starting kernel ..." was the new U-Boot starting up. Instead, it simply hung. The "working config" gives me: Starting kernel ... U-Boot 2010.06 (Mar 18 2011 - 13:24:33) DNS323B1 SoC: Orion5x MV88F5182-A2 DRAM: 64 MiB Flash: 8 MiB *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: egiga0 88E1116 Initialized on egiga0 DNS323B1> The non-working one just hangs. Regards, Rogan _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
