On 9/22/23 12:08, Alexander Dahl wrote:
Adapt behaviour to Linux kernel driver.

The return value of gpio_request_by_name_nodev() was not checked before,
and thus in case 'rb-gpios' was missing in DT, rb.type was set to
ATMEL_NAND_GPIO_RB nevertheless, leading to output like this for
example (on sam9x60-curiosity with the line removed from dts):

     NAND:  Could not find valid ONFI parameter page; aborting
     device found, Manufacturer ID: 0xc2, Chip ID: 0xdc
     Macronix NAND 512MiB 3,3V 8-bit
     512 MiB, SLC, erase size: 256 KiB, page size: 4096, OOB size: 64
     atmel-nand-controller nand-controller: NAND scan failed: -22
     Failed to probe nand driver (err = -22)
     Failed to initialize NAND controller. (error -22)
     0 MiB

Note: not having that gpio assigned in dts is possible, the driver does
not override nand_chip->dev_ready() then and a generic solution is used.

Fixes: 6a8dfd57220d ("nand: atmel: Add DM based NAND driver")
Signed-off-by: Alexander Dahl <a...@thorsis.com>
---

Reviewed-by: Eugen Hristev <eugen.hris...@collabora.com>


Notes:
     v1 -> v2:
- Only issue error message if error is not ENOENT. If the node just is
       missing, move on without error message.

  drivers/mtd/nand/raw/atmel/nand-controller.c | 11 +++++++----
  1 file changed, 7 insertions(+), 4 deletions(-)


Reply via email to