Dear Maik Hänig, > Hi, > > > I change my uboot version and after it the uboot don't starts the same > linux kernel: > > ## Booting kernel from Legacy Image at 10060000 ... _________________________________________???????? > Image Name: Linux Kernel > Image Type: ARM Linux Kernel Image (gzip compressed) > Data Size: 1178673 Bytes = 1.1 MiB > Load Address: 20008000 > Entry Point: 20008000 > Verifying Checksum ... OK > Uncompressing Kernel Image ... OK > > Starting kernel ... > > *****LOG END***** > > > It's a board simular to the at91rm9200dk. I start the kernel with > > bootcmd2=setenv bootargs root=/dev/mtdblock9 rootfstype=squashfs > ETHADDR=$(ethaddr) RUNNING=$(runningimage) CFGFS=mtdblock10;bootm 0x30060000 ______________________________________________________________________???????? > > run bootcmd2
First, I don't understand why those two addresses are not the same. Then, are you sure your "bootcmd2" ist really what you think it is? Try a "printenv" and see whats really there. Should you not have a "console=xxx" in your kernel parameters? Besides once "Starting kernel ..." shows, u-boot is about to give control to the kernel, all future output would be from the kernel itself, probably needing a sane "console=xxx" parameter. Best Regards, Reinhard _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
