[PATCH V4 06/12] board: ti: j721s2: Add support for detecting multiple device trees

[Sinthu Raja]

From: Sinthu Raja <sinthu.r...@ti.com>

Update the board_fit_config_name_match() to choose the right dtb
based on the board name read from EEPROM.

Also restrict multpile EEPROM reads by verifying if EEPROM is already
read

Signed-off-by: Sinthu Raja <sinthu.r...@ti.com>
---
 board/ti/j721s2/evm.c | 30 ++++++++++++++++++++----------
 1 file changed, 20 insertions(+), 10 deletions(-)

diff --git a/board/ti/j721s2/evm.c b/board/ti/j721s2/evm.c
index a3adb8704e..a7c4082a7a 100644
--- a/board/ti/j721s2/evm.c
+++ b/board/ti/j721s2/evm.c
@@ -72,16 +72,6 @@ int dram_init_banksize(void)
        return 0;
 }
 
-#ifdef CONFIG_SPL_LOAD_FIT
-int board_fit_config_name_match(const char *name)
-{
-       if (!strcmp(name, "k3-j721s2-common-proc-board"))
-               return 0;
-
-       return -1;
-}
-#endif
-
 #if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP)
 int ft_board_setup(void *blob, struct bd_info *bd)
 {
@@ -111,6 +101,9 @@ int do_board_detect(void)
 {
        int ret;
 
+       if (board_ti_was_eeprom_read())
+               return 0;
+
        ret = ti_i2c_eeprom_am6_get_base(CONFIG_EEPROM_BUS_ADDRESS,
                                         CONFIG_EEPROM_CHIP_ADDRESS);
        if (ret) {
@@ -179,6 +172,23 @@ static void setup_serial(void)
 }
 #endif
 
+#ifdef CONFIG_SPL_LOAD_FIT
+int board_fit_config_name_match(const char *name)
+{
+       bool eeprom_read = board_ti_was_eeprom_read();
+
+       if (!eeprom_read || board_is_j721s2_som()) {
+               if (!strcmp(name, "k3-j721s2-common-proc-board"))
+                       return 0;
+       } else if (!eeprom_read || board_is_am68_sk_som()) {
+               if (!strcmp(name, "k3-am68-sk-base-board"))
+                       return 0;
+       }
+
+       return -1;
+}
+#endif
+
 int board_late_init(void)
 {
        if (IS_ENABLED(CONFIG_TI_I2C_BOARD_DETECT)) {
-- 
2.36.1