On 01/12/2011 02:34 AM, Thomas Besemer wrote:
> Hi Stefano -
>
Hi Thomas,
> Looks like the problem I was having is the Freescale SDK (LTIB) had a
> .config file that ended up with the wrong load address; was picking up
> the MX53 (0x70008000 versus 0x90008000) load/build addys.
Well, then it is clear why the board does not boot...
> Don't know
> why it ever worked....
I can only say I have tested with Freescale's kernel, too, and it
worked. Probably I tried with a version before the introduction of MX53,
and the address was correct.
> I was also able to boot over network without issues.
>
> I don't install uImage on a partition, rather, hand install it on SD
> card with DD, and then load with this:
>
> bootcmd_mmc=run bootargs_base bootargs_mmc; mmc read 0 ${loadaddr}
> 0x800 0x1800;bootm
>
> Just pulls from an offset in SD card. Works fine.
Fine, thanks to report to the ML your results.
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
