This patch add I2C interface for fsl_pmic driver support

Signed-off-by: Jason Liu <r64...@freescale.com>

---
Changes for v2:
- Address the comments from Stefano,
  - factor out the param_check in pmic_reg for both spi/i2c
- Address the comments from Stefano,
  - Remvove call i2c_init again
  - Fix one logic path for pmic_read issue. Here the pmic dump
    command output:
        MX53EVK U-Boot > pmic dump 4
        PMIC ID: 0x000045d0 [Rev: 2.0]

        0x00: 00015088 00ffffff 00395208 00004081
---
 drivers/misc/fsl_pmic.c |   45 ++++++++++++++++++++++++++++++++++++++++-----
 1 files changed, 40 insertions(+), 5 deletions(-)

diff --git a/drivers/misc/fsl_pmic.c b/drivers/misc/fsl_pmic.c
index 5ee1de1..ef80ad9 100644
--- a/drivers/misc/fsl_pmic.c
+++ b/drivers/misc/fsl_pmic.c
@@ -22,11 +22,48 @@
 
 #include <config.h>
 #include <common.h>
-#include <spi.h>
 #include <asm/errno.h>
 #include <linux/types.h>
 #include <fsl_pmic.h>
 
+static int check_param(u32 reg, u32 write)
+{
+       if (reg > 63 || write > 1) {
+               printf("<reg num> = %d is invalid. Should be less then 63\n",
+                       reg);
+               return -1;
+       }
+
+       return 0;
+}
+
+#ifdef CONFIG_FSL_PMIC_I2C
+#include <i2c.h>
+
+u32 pmic_reg(u32 reg, u32 val, u32 write)
+{
+       unsigned char buf[4] = { 0 };
+       u32 ret_val = 0;
+
+       if (check_param(reg, write))
+               return -1;
+
+       if (write) {
+               buf[0] = (val >> 16) & 0xff;
+               buf[1] = (val >> 8) & 0xff;
+               buf[2] = (val) & 0xff;
+               if (i2c_write(CONFIG_SYS_FSL_PMIC_I2C_ADDR, reg, 1, buf, 3))
+                       return -1;
+       } else {
+               if (i2c_read(CONFIG_SYS_FSL_PMIC_I2C_ADDR, reg, 1, buf, 3))
+                       return -1;
+               ret_val = buf[0] << 16 | buf[1] << 8 | buf[2];
+       }
+
+       return ret_val;
+}
+#else /* SPI interface */
+#include <spi.h>
 static struct spi_slave *slave;
 
 struct spi_slave *pmic_spi_probe(void)
@@ -55,11 +92,8 @@ u32 pmic_reg(u32 reg, u32 val, u32 write)
                        return -1;
        }
 
-       if (reg > 63 || write > 1) {
-               printf("<reg num> = %d is invalid. Should be less then 63\n",
-                       reg);
+       if (check_param(reg, write))
                return -1;
-       }
 
        if (spi_claim_bus(slave))
                return -1;
@@ -87,6 +121,7 @@ u32 pmic_reg(u32 reg, u32 val, u32 write)
        spi_release_bus(slave);
        return cpu_to_be32(pmic_rx);
 }
+#endif
 
 void pmic_reg_write(u32 reg, u32 value)
 {
-- 
1.7.0.4


_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to