On 2022-03-11 11:19, Marek Vasut wrote:
On 3/11/22 19:41, Angus Ainslie wrote:
On 2022-03-11 10:05, Marek Vasut wrote:
On 3/11/22 18:02, Angus Ainslie wrote:
On 2022-03-11 08:57, Marek Vasut wrote:
On 3/11/22 17:35, Angus Ainslie wrote:
All of the PLLs and clocks are initialized so the subsystems below
are
functional and tested.
1) USB host and peripheral
2) ECSPI
3) UART
4) I2C all busses
5) USDHC for eMMC support
6) USB storage
7) GPIO
8) DRAM
The PLL rate tables are from the kernel
https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/commit/?id=43cdaa1567ad3931fbde438853947d45238cc040
That patch is three years old.
That patch is for MX8M Mini clock, not for MX8M(Q).
You can use the abbreviated commit ID instead:
43cdaa1567ad3 ("clk: imx8mm: Move 1443X/1416X PLL clock structure
to common place")
But that seems to be the wrong commit.
That's the commit where the imx8m PLL frequency table is moved to a
common file for use by all of the imx8m variants. The imx8mq linux
driver does not even use the frequency tables so there is not a
specific commit for it.
Isn't large part of this driver coming from these tables ?
https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/log/drivers/clk/imx/clk-imx8mq.c
When I said tables I was referring to the PLL frequency tables.
Ahh, hmmm, I see that we now have three copies of those PLL tables in
each MX8M{M,N,P} driver and Linux instead has this in common code. Can
you deduplicate the PLL tables before we add fourth copy ?
Ok I can do that for the imx8m* clock drivers.
The driver is modelled after the u-boot imx8mm u-boot driver with
register and mux updates from the imx8mq reference manual. Very little
comes from the imx8mq kernel driver. Mainly I just verified mux naming
and register offsets against that driver.
Would it make sense to pick the Linux kernel tables instead then,
instead of hand-writing them from scratch ? That seems error prone.
It's a good thing I didn't just copy the kernel drivers because I found
an error there. After this driver accepted there will very few if any
updates to the mux tables as I think most if not all of the clocks
you'll need in u-boot are defined. If there are any future updates those
could be cut and pasted.
