Jocke, [snip]
> still -E_TOO_LITTLE_INFO: > sorry - thought it was clear already. > "include weather booted from NAND or NOR, CPU type(e300cX) and > what reset vector is used." > CPU: e300c4, MPC8379, Rev: 2.1 at 600 MHz, CSB: 400 MHz - Boot from NOR Flash - HRCW from I2C EEPROM - Reset Vector 0x100, i.e. low boot. Initial RAM ... #define CONFIG_SYS_INIT_RAM_LOCK 1 #define CONFIG_SYS_INIT_RAM_ADDR 0xE6000000 #define CONFIG_SYS_INIT_RAM_SIZE 0x1000 #define CONFIG_SYS_GBL_DATA_SIZE 0x100 #define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - CONFIG_SYS_GBL_DATA_SIZE) ... mapped by BAT5 #define CONFIG_SYS_IBAT5L (CONFIG_SYS_INIT_RAM_ADDR | BATL_PP_10) #define CONFIG_SYS_IBAT5U (CONFIG_SYS_INIT_RAM_ADDR | BATU_BL_128K | BATU_VS | BATU_VP) #define CONFIG_SYS_DBAT5L CONFIG_SYS_IBAT5L #define CONFIG_SYS_DBAT5U CONFIG_SYS_IBAT5U Of course ELDK-4.2 toolchain. >> My latest MPC8377 board does not even start without your suggested 4 nops. >> It does not start (i.e. serial line completely dead) with any USB >> functionality defined. >> > Something else is broken here, no idea what. > > If it's an alignment or linking problem it could have the same root cause. Just want to give as much information as I can. Cheers, André MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler Registergericht: Amtsgericht Stuttgart, HRB 271090 Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
