Dear Peter Tyser,
In message <1288156533.1971.6.ca...@ptyser-laptop> you wrote:
>
> Can you send the entire bootup output? The code is based on Freescale
> reference boards, eg the mpc8568mds, so I'd guess the problem is not
> tqm85xx-specific.
Sure. Here it is:
U-Boot 2010.09-00558-g79e6313 (Oct 26 2010 - 21:31:41)
CPU: 8555E, Version: 1.1, (0x80790011)
Core: Unknown, Version: 2.0, (0x80200020)
Clock Configuration:
CPU0:833.333 MHz,
CCB:333.333 MHz,
DDR:166.667 MHz (333.333 MT/s data rate), LBC:41.667 MHz
CPM: 333.333 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: TQM8555, serial# ABC0555 casl=25
I2C: ready
DRAM: 128 MiB
FLASH: 128 MiB
L2: 256 KB already enabled
PCI1: 32 bit, 33 MHz, sync, host, arbiter
Scanning PCI bus 00
PCIE1 on bus 00 - 00
PCI-X will only work at 66 MHz
In: serial
Out: serial
Err: serial
DTT: 1 is 41 C
Net: FCC1, TSEC0 [PRIME], TSEC1
PS/2: No device found
Kbd: reset failed, no ACK
Type run flash_nfs to mount root filesystem over NFS
Hit any key to stop autoboot: 0
=>
Please also note the "Core: Unknown" which is new.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Hiring experienced unix people is like a built-in filter against
idiots. Hiring experienced NT people provides no such guarantee.
-- Miguel Cruz in wgl96.349$cc.122...@typhoon2.ba-dsg.net
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
