On 6/4/21 11:30 AM, Aswath Govindraju wrote:
The following series of patches add support for the following
- Kconfig symbol for giving the load address for ATF
- USB Mass storage boot mode in AM642-EVM
- DFU boot mode in AM642-EVM
- Host and peripheral modes for AM642-EVM in U-Boot
- Set the USB PHY core voltage to 0.85V
changes since v2,
- Increased the max size of ATF in patch 9
Please confirm if this is tested on ATF 2.5 too.
- Added reviewed-by from Suman Anna in patch 1
- Reworded the subject of patch 8
changes since v1,
- Corrected the default load address of ATF to
0x70000000
Aswath Govindraju (10):
tools: k3_fit_atf: Add support for providing ATF load address using a
Kconfig symbol
arm: mach-k3: am642_init: Add support for USB boot mode
arm: mach-k3: am642_init: Do USB fixups to facilitate host and device
boot modes
board: ti: am64x: Set the core voltage of USB PHY to 0.85V
arm: dts: k3-am64-main: Add USB DT nodes
arm: dts: k3-am642-*-evm: Add USB support
arm: dts: k3-am642-evm-u-boot: Add U-Boot tags and fix the dr_mode to
peripheral for USB subsystem
configs: am64x_evm_*_defconfig: Rearrange the components in SRAM to
satisfy the limitations for USB DFU boot mode
arm: dts: k3-am64-main: Update the location of ATF in SRAM and
increase its max size
configs: am64: Enable configs to support USB host and device modes
arch/arm/dts/k3-am64-main.dtsi | 32 ++++++++++++-
arch/arm/dts/k3-am642-evm-u-boot.dtsi | 13 ++++++
arch/arm/dts/k3-am642-evm.dts | 18 ++++++++
arch/arm/dts/k3-am642-r5-evm.dts | 18 ++++++++
arch/arm/mach-k3/Kconfig | 7 +++
arch/arm/mach-k3/am642_init.c | 46 ++++++++++++++++++-
arch/arm/mach-k3/config.mk | 1 +
arch/arm/mach-k3/include/mach/am64_hardware.h | 11 +++--
arch/arm/mach-k3/include/mach/am64_spl.h | 6 ++-
board/ti/am64x/evm.c | 14 ++++++
configs/am64x_evm_a53_defconfig | 40 ++++++++++++++++
configs/am64x_evm_r5_defconfig | 38 +++++++++++++--
include/configs/am64x_evm.h | 15 +++++-
tools/k3_fit_atf.sh | 9 ++--
14 files changed, 251 insertions(+), 17 deletions(-)
