There are drivers to support built in USB controller and PHY-s now, so lets add
the USB nodes to DTSI.
Signed-off-by: Robert Marko <robert.ma...@sartura.hr>
Cc: Luka Perkov <luka.per...@sartura.hr>
---
arch/arm/dts/qcom-ipq4019.dtsi | 50 ++++++++++++++++++++++++++++++++++
1 file changed, 50 insertions(+)
diff --git a/arch/arm/dts/qcom-ipq4019.dtsi b/arch/arm/dts/qcom-ipq4019.dtsi
index 7b15df38d8..494b2205a5 100644
--- a/arch/arm/dts/qcom-ipq4019.dtsi
+++ b/arch/arm/dts/qcom-ipq4019.dtsi
@@ -90,5 +90,55 @@
gpio-bank-name="soc";
#gpio-cells = <2>;
};
+
+ usb3_ss_phy: ssphy@9a000 {
+ compatible = "qcom,usb-ss-ipq4019-phy";
+ #phy-cells = <0>;
+ reg = <0x9a000 0x800>;
+ reg-names = "phy_base";
+ resets = <&reset USB3_UNIPHY_PHY_ARES>;
+ reset-names = "por_rst";
+ status = "disabled";
+ };
+
+ usb3_hs_phy: hsphy@a6000 {
+ compatible = "qcom,usb-hs-ipq4019-phy";
+ #phy-cells = <0>;
+ reg = <0xa6000 0x40>;
+ reg-names = "phy_base";
+ resets = <&reset USB3_HSPHY_POR_ARES>, <&reset
USB3_HSPHY_S_ARES>;
+ reset-names = "por_rst", "srif_rst";
+ status = "disabled";
+ };
+
+ usb3: xhci@8a00000 {
+ compatible = "qcom,dwc3-ipq";
+ reg = <0x8a00000 0xcd00>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ phys = <&usb3_hs_phy>, <&usb3_ss_phy>;
+ phy-names = "usb2-phy", "usb3-phy";
+ status = "disabled";
+ };
+
+ usb2_hs_phy: hsphy@a8000 {
+ compatible = "qcom,usb-hs-ipq4019-phy";
+ #phy-cells = <0>;
+ reg = <0xa8000 0x40>;
+ reg-names = "phy_base";
+ resets = <&reset USB2_HSPHY_POR_ARES>, <&reset
USB2_HSPHY_S_ARES>;
+ reset-names = "por_rst", "srif_rst";
+ status = "disabled";
+ };
+
+ usb2: xhci@6000000 {
+ compatible = "qcom,dwc3-ipq";
+ reg = <0x6000000 0xcd00>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ phys = <&usb2_hs_phy>;
+ phy-names = "usb2-phy";
+ status = "disabled";
+ };
};
};
--
2.26.2
