On Wed, 1 Jul 2020 at 20:11, Vladimir Oltean <olte...@gmail.com> wrote: > > Hi Zhiqiang, > > On Wed, 1 Jul 2020 at 20:05, Zhiqiang Hou <zhiqiang....@nxp.com> wrote: > > > > From: Hou Zhiqiang <zhiqiang....@nxp.com> > > > > This patch set depends on: > > https://patchwork.ozlabs.org/project/uboot/patch/20200503185227.28731-2-olte...@gmail.com/ > > > > Hou Zhiqiang (16): > > net: fsl_mdio: Change to use virtual address > > net: fsl_mdio: Correct the MII management register block address > > net: tsec: convert to use DM_MDIO when DM_ETH enabled > > net: tsec: Add fixed-link PHY support > > net: tsec: Add the compatible string "gianfar" support > > powerpc: mpc8xxx: Don't compile cpu_eth_init() when DM_ETH enabled > > fsl: p1_p2_rdb: Move vsc7835 firmware uploading to > > board_early_init_r() > > configs: p1_p2_rdb: Add the default address of vsc7385 firmware > > dts: powerpc: p1020rdb: Add eTSEC DT nodes > > powerpc: p1_p2_rdb: Don't compile board_eth_init() when DM_ETH enabled > > configs: P1020RDB: Enable DM_ETH config > > dts: powerpc: p1010rdb: Add eTSEC DT nodes > > powerpc: p1010rdb: Compile legacy ethernet init function when no > > DM_ETH > > configs: P1010RDB: Enable DM_ETH config > > dts: powerpc: p2020rdb: Add eTSEC DT nodes > > configs: P2020RDB: Enable DM_ETH config > > > > arch/powerpc/cpu/mpc8xxx/cpu.c | 2 + > > arch/powerpc/dts/p1010rdb-pa.dts | 1 + > > arch/powerpc/dts/p1010rdb-pa_36b.dts | 1 + > > arch/powerpc/dts/p1010rdb.dtsi | 50 +++++++++++++++ > > arch/powerpc/dts/p1010si-post.dtsi | 25 ++++++++ > > arch/powerpc/dts/p1020-post.dtsi | 20 +++++- > > arch/powerpc/dts/p1020rdb-pc.dts | 1 + > > arch/powerpc/dts/p1020rdb-pc.dtsi | 55 ++++++++++++++++ > > arch/powerpc/dts/p1020rdb-pc_36b.dts | 1 + > > arch/powerpc/dts/p1020rdb-pd.dts | 45 ++++++++++++++ > > arch/powerpc/dts/p2020-post.dtsi | 10 ++- > > arch/powerpc/dts/p2020rdb-pc.dts | 1 + > > arch/powerpc/dts/p2020rdb-pc.dtsi | 50 +++++++++++++++ > > arch/powerpc/dts/p2020rdb-pc_36b.dts | 1 + > > arch/powerpc/dts/pq3-etsec1-0.dtsi | 28 +++++++++ > > arch/powerpc/dts/pq3-etsec1-1.dtsi | 28 +++++++++ > > arch/powerpc/dts/pq3-etsec1-2.dtsi | 28 +++++++++ > > arch/powerpc/dts/pq3-etsec1-3.dtsi | 28 +++++++++ > > arch/powerpc/dts/pq3-etsec2-0.dtsi | 35 +++++++++++ > > arch/powerpc/dts/pq3-etsec2-1.dtsi | 35 +++++++++++ > > arch/powerpc/dts/pq3-etsec2-2.dtsi | 35 +++++++++++ > > arch/powerpc/dts/pq3-etsec2-grp2-0.dtsi | 16 +++++ > > arch/powerpc/dts/pq3-etsec2-grp2-1.dtsi | 16 +++++ > > arch/powerpc/dts/pq3-etsec2-grp2-2.dtsi | 16 +++++ > > board/freescale/p1010rdb/p1010rdb.c | 2 + > > board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c | 37 ++++++----- > > configs/P1010RDB-PA_36BIT_NAND_defconfig | 2 + > > configs/P1010RDB-PA_36BIT_NOR_defconfig | 2 + > > configs/P1010RDB-PA_36BIT_SDCARD_defconfig | 2 + > > configs/P1010RDB-PA_36BIT_SPIFLASH_defconfig | 2 + > > configs/P1010RDB-PA_NAND_defconfig | 2 + > > configs/P1010RDB-PA_NOR_defconfig | 2 + > > configs/P1010RDB-PA_SDCARD_defconfig | 2 + > > configs/P1010RDB-PA_SPIFLASH_defconfig | 2 + > > configs/P1010RDB-PB_36BIT_NAND_defconfig | 2 + > > configs/P1010RDB-PB_36BIT_NOR_defconfig | 2 + > > configs/P1010RDB-PB_36BIT_SDCARD_defconfig | 2 + > > configs/P1010RDB-PB_36BIT_SPIFLASH_defconfig | 2 + > > configs/P1010RDB-PB_NAND_defconfig | 2 + > > configs/P1010RDB-PB_NOR_defconfig | 2 + > > configs/P1010RDB-PB_SDCARD_defconfig | 2 + > > configs/P1010RDB-PB_SPIFLASH_defconfig | 2 + > > configs/P1020RDB-PC_36BIT_NAND_defconfig | 3 + > > configs/P1020RDB-PC_36BIT_SDCARD_defconfig | 3 + > > configs/P1020RDB-PC_36BIT_SPIFLASH_defconfig | 3 + > > configs/P1020RDB-PC_36BIT_defconfig | 3 + > > configs/P1020RDB-PC_NAND_defconfig | 3 + > > configs/P1020RDB-PC_SDCARD_defconfig | 3 + > > configs/P1020RDB-PC_SPIFLASH_defconfig | 3 + > > configs/P1020RDB-PC_defconfig | 3 + > > configs/P1020RDB-PD_NAND_defconfig | 3 + > > configs/P1020RDB-PD_SDCARD_defconfig | 3 + > > configs/P1020RDB-PD_SPIFLASH_defconfig | 3 + > > configs/P1020RDB-PD_defconfig | 3 + > > configs/P2020RDB-PC_36BIT_NAND_defconfig | 3 + > > configs/P2020RDB-PC_36BIT_SDCARD_defconfig | 3 + > > configs/P2020RDB-PC_36BIT_SPIFLASH_defconfig | 3 + > > configs/P2020RDB-PC_36BIT_defconfig | 3 + > > configs/P2020RDB-PC_NAND_defconfig | 3 + > > configs/P2020RDB-PC_SDCARD_defconfig | 3 + > > configs/P2020RDB-PC_SPIFLASH_defconfig | 3 + > > configs/P2020RDB-PC_defconfig | 3 + > > doc/device-tree-bindings/net/fsl-tsec-phy.txt | 2 +- > > drivers/net/fsl_mdio.c | 28 +++++++-- > > drivers/net/tsec.c | 62 ++++++++----------- > > include/configs/p1_p2_rdb_pc.h | 2 + > > include/fsl_mdio.h | 4 ++ > > include/tsec.h | 4 ++ > > 68 files changed, 698 insertions(+), 63 deletions(-) > > create mode 100644 arch/powerpc/dts/p1020rdb-pc.dtsi > > create mode 100644 arch/powerpc/dts/p2020rdb-pc.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec1-0.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec1-1.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec1-2.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec1-3.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec2-0.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec2-1.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec2-2.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec2-grp2-0.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec2-grp2-1.dtsi > > create mode 100644 arch/powerpc/dts/pq3-etsec2-grp2-2.dtsi > > > > -- > > 2.25.1 > > > > The point with the Acked-by/Reviewed-by/Tested-by tags is that you > copy them to your next patch submissions, such that the maintainers > see which patches have had eyes on them already, so that they don't > need to look through them again. > > Thanks, > -Vladimir
I'm sorry, please ignore this. I thought none of the patches have the Reviewed-by tag I added, but looks like those are in fact all the patches that I did review. Time to review the rest! Thanks, -Vladimir
