Hi Tero,
On 02/06/20 4:49 pm, Tero Kristo wrote:
> Hi,
>
> As there is looming death to OMAP4 Panda board u-boot support, I decided
> to take a shot and convert it to device model myself. With these patches
> it boots up fine, and there are no DM_SPL conversion complaints during
> compile time anymore. I think USB ethernet does not work anymore with
> this, but its better than dropping the support for the board completely.
> USB itself appears working, so it should be relatively easy for someone
> to fix the networking support if they need it.
I see the below warning with these patches:
board/ti/panda/panda.c:329:35: warning: ‘struct ehci_hcor’ declared inside
parameter list will not be visible outside of this definition or declaration
329 | struct ehci_hccr **hccr, struct ehci_hcor **hcor)
| ^~~~~~~~~
board/ti/panda/panda.c:329:10: warning: ‘struct ehci_hccr’ declared inside
parameter list will not be visible outside of this definition or declaration
329 | struct ehci_hccr **hccr, struct ehci_hcor **hcor)
| ^~~~~~~~~
board/ti/panda/panda.c: In function ‘ehci_hcd_init’:
board/ti/panda/panda.c:339:8: warning: implicit declaration of function
‘omap_ehci_hcd_init’; did you mean ‘ehci_hcd_init’?
[-Wimplicit-function-declaration]
339 | ret = omap_ehci_hcd_init(index, &usbhs_bdata, hccr, hcor);
| ^~~~~~~~~~~~~~~~~~
| ehci_hcd_init
board/ti/panda/panda.c: In function ‘ehci_hcd_stop’:
board/ti/panda/panda.c:348:9: warning: implicit declaration of function
‘omap_ehci_hcd_stop’; did you mean ‘ehci_hcd_stop’?
[-Wimplicit-function-declaration]
348 | return omap_ehci_hcd_stop();
| ^~~~~~~~~~~~~~~~~~
| ehci_hcd_stop
Thanks and regards,
Lokesh
>
> -Tero
>
>
> --
> Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
> Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
>
