Hello Heiko Am 05.08.2010 08:19, schrieb Heiko Schocher: >> The board runs through my low level init (so DDR RAM is up) and later on >> crashes in the first call to memset. I could not further debug this as I > > Where is this memset()? The first after low level init is in: > arch/arm/lib/board.c board_init_f(), do you mean this?
Yes. That was the point it crashed. > If so, then something must be wrong with your memory setup. It was at more then one point :-) > Hmmm... from where did your board boot? I tried it on the tx25 > board, which boots from nand. Do you boot from a NOR flash? Yes. My board boots from NOR. > If so you *must* change TEXT_BASE in config.mk (see: > doc/README.arm-relocation line 45) in your board directory > to where u-boot starts in flash! I think I missed that point. > Ah, yep, this seems to me the reason why it don;t work for you: > > found in the patchseries you pointed to > http://lists.denx.de/pipermail/u-boot/2010-August/074688.html > > board/syteco/jadecpu/config.mk > [...] > +TEXT_BASE = 0x46000000 > > change this to > > (as in include/configs/jadecpu.h is defined the following: > > +/* > + * FLASH and environment organization > + */ > +#define CONFIG_SYS_FLASH_BASE 0x10000000 > +#define CONFIG_SYS_MAX_FLASH_BANKS 1 > +#define CONFIG_SYS_MAX_FLASH_SECT 256 > +#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_FLASH_BASE > ) > > +TEXT_BASE = 0x10000000 > > and try it again. I did that but the board still failed to boot and crashed at the first call to memset. So I had a "nice" debug session single stepping through the code with a lss file in parallel. The reason it crashed so early was my setup of CONFIG_SYS_INIT_SP_ADDR which I set to the *beginning* of some 32k internal SRAM. And as the stack grows downwards it crashed right at the first push instruction. So, I now have a running system with your patches and greatly improved uncompressing times of my boot images. We are now able to use compressed images which was not possible due to boot time restrictions in older versions. So it would be great if this stuff could go mainline. Thanks, Matthias _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot