This patch is updating ls2088aqds board init code to support DM_I2C.
Signed-off-by: Chuanhua Han <chuanhua....@nxp.com>
---
depends on:
- http://patchwork.ozlabs.org/project/uboot/list/?series=118772
- http://patchwork.ozlabs.org/project/uboot/list/?series=117226
board/freescale/ls2080aqds/eth.c | 75 +++++++++++++++++++++++++++++++++
board/freescale/ls2080aqds/ls2080aqds.c | 8 ++++
include/configs/ls2080aqds.h | 3 ++
3 files changed, 86 insertions(+)
diff --git a/board/freescale/ls2080aqds/eth.c b/board/freescale/ls2080aqds/eth.c
index f706fd4..b1d6827 100644
--- a/board/freescale/ls2080aqds/eth.c
+++ b/board/freescale/ls2080aqds/eth.c
@@ -107,7 +107,16 @@ static void sgmii_configure_repeater(int serdes_port)
int *riser_phy_addr = &xqsgii_riser_phy_addr[0];
/* Set I2c to Slot 1 */
+#ifndef CONFIG_DM_I2C
i2c_write(0x77, 0, 0, &a, 1);
+#else
+ struct udevice *udev;
+
+ ret = i2c_get_chip_for_busnum(0, 0x77, 1, &udev);
+ if (!ret)
+ dm_i2c_write(udev, 0, &a, 1);
+#endif
+
for (dpmac = 0; dpmac < 8; dpmac++) {
/* Check the PHY status */
@@ -120,7 +129,14 @@ static void sgmii_configure_repeater(int serdes_port)
mii_bus = 1;
dpmac_id = dpmac + 9;
a = 0xb;
+#ifndef CONFIG_DM_I2C
i2c_write(0x76, 0, 0, &a, 1);
+#else
+ ret = i2c_get_chip_for_busnum(0, 0x76, 1, &udev);
+ if (!ret)
+ dm_i2c_write(udev, 0, &a, 1);
+#endif
+
break;
}
@@ -153,6 +169,7 @@ static void sgmii_configure_repeater(int serdes_port)
for (i = 0; i < 4; i++) {
for (j = 0; j < 4; j++) {
+#ifndef CONFIG_DM_I2C
a = 0x18;
i2c_write(i2c_addr[dpmac], 6, 1, &a, 1);
a = 0x38;
@@ -176,6 +193,31 @@ static void sgmii_configure_repeater(int serdes_port)
i2c_write(i2c_addr[dpmac], 0x2d, 1, &a, 1);
a = 0x20;
i2c_write(i2c_addr[dpmac], 4, 1, &a, 1);
+#else
+ i2c_get_chip_for_busnum(0, i2c_addr[dpmac],
+ 1, &udev);
+
+ a = 0x18;
+ dm_i2c_write(udev, 6, &a, 1);
+ a = 0x38;
+ dm_i2c_write(udev, 4, &a, 1);
+ a = 0x4;
+ dm_i2c_write(udev, 8, &a, 1);
+
+ dm_i2c_write(udev, 0xf, &ch_a_eq[i], 1);
+ dm_i2c_write(udev, 0x11, &ch_a_ctl2[j], 1);
+
+ dm_i2c_write(udev, 0x16, &ch_b_eq[i], 1);
+ dm_i2c_write(udev, 0x18, &ch_b_ctl2[j], 1);
+
+ a = 0x14;
+ dm_i2c_write(udev, 0x23, &a, 1);
+ a = 0xb5;
+ dm_i2c_write(udev, 0x2d, &a, 1);
+ a = 0x20;
+ dm_i2c_write(udev, 4, &a, 1);
+
+#endif
mdelay(100);
ret = miiphy_read(dev[mii_bus],
riser_phy_addr[dpmac],
@@ -231,7 +273,15 @@ static void qsgmii_configure_repeater(int dpmac)
unsigned short value;
/* Set I2c to Slot 1 */
+#ifndef CONFIG_DM_I2C
i2c_write(0x77, 0, 0, &a, 1);
+#else
+ struct udevice *udev;
+
+ ret = i2c_get_chip_for_busnum(0, 0x77, 1, &udev);
+ if (!ret)
+ dm_i2c_write(udev, 0, &a, 1);
+#endif
switch (dpmac) {
case 1:
@@ -282,6 +332,7 @@ static void qsgmii_configure_repeater(int dpmac)
for (i = 0; i < 4; i++) {
for (j = 0; j < 4; j++) {
+#ifndef CONFIG_DM_I2C
a = 0x18;
i2c_write(i2c_phy_addr, 6, 1, &a, 1);
a = 0x38;
@@ -301,6 +352,30 @@ static void qsgmii_configure_repeater(int dpmac)
i2c_write(i2c_phy_addr, 0x2d, 1, &a, 1);
a = 0x20;
i2c_write(i2c_phy_addr, 4, 1, &a, 1);
+#else
+ i2c_get_chip_for_busnum(0, i2c_phy_addr, 1, &udev);
+ a = 0x18;
+ dm_i2c_write(udev, 6, &a, 1);
+ a = 0x38;
+ dm_i2c_write(udev, 4, &a, 1);
+ a = 0x4;
+ dm_i2c_write(udev, 8, &a, 1);
+
+ dm_i2c_write(udev, 0xf, &ch_a_eq[i], 1);
+ dm_i2c_write(udev, 0x11, &ch_a_ctl2[j], 1);
+
+ dm_i2c_write(udev, 0x16, &ch_b_eq[i], 1);
+ dm_i2c_write(udev, 0x18, &ch_b_ctl2[j], 1);
+
+ a = 0x14;
+ dm_i2c_write(udev, 0x23, &a, 1);
+ a = 0xb5;
+ dm_i2c_write(udev, 0x2d, &a, 1);
+ a = 0x20;
+ dm_i2c_write(udev, 4, &a, 1);
+
+#endif
+
mdelay(100);
ret = miiphy_read(dev, phy_addr, 0x11, &value);
if (ret > 0)
diff --git a/board/freescale/ls2080aqds/ls2080aqds.c
b/board/freescale/ls2080aqds/ls2080aqds.c
index a0a3301..21038a5 100644
--- a/board/freescale/ls2080aqds/ls2080aqds.c
+++ b/board/freescale/ls2080aqds/ls2080aqds.c
@@ -161,7 +161,15 @@ int select_i2c_ch_pca9547(u8 ch)
{
int ret;
+#ifndef CONFIG_DM_I2C
ret = i2c_write(I2C_MUX_PCA_ADDR_PRI, 0, 1, &ch, 1);
+#else
+ struct udevice *dev;
+
+ ret = i2c_get_chip_for_busnum(0, I2C_MUX_PCA_ADDR_PRI, 1, &dev);
+ if (!ret)
+ ret = dm_i2c_write(dev, 0, &ch, 1);
+#endif
if (ret) {
puts("PCA: failed to select proper channel\n");
return ret;
diff --git a/include/configs/ls2080aqds.h b/include/configs/ls2080aqds.h
index 18f30b5..05ff770 100644
--- a/include/configs/ls2080aqds.h
+++ b/include/configs/ls2080aqds.h
@@ -16,7 +16,9 @@ unsigned long get_board_ddr_clk(void);
#ifdef CONFIG_FSL_QSPI
#define CONFIG_QIXIS_I2C_ACCESS
+#ifndef CONFIG_DM_I2C
#define CONFIG_SYS_I2C_EARLY_INIT
+#endif
#define CONFIG_SYS_I2C_IFDR_DIV 0x7e
#endif
@@ -324,6 +326,7 @@ unsigned long get_board_ddr_clk(void);
*/
#define RTC
#define CONFIG_RTC_DS3231 1
+#define CONFIG_RTC_ENABLE_32KHZ_OUTPUT
#define CONFIG_SYS_I2C_RTC_ADDR 0x68
/* EEPROM */
--
2.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
