On 5/9/19 5:03 PM, Vasily Khoruzhick wrote: > On Thu, May 9, 2019 at 7:56 AM Marek Vasut <ma...@denx.de> wrote: >> >> On 5/9/19 4:02 PM, Tom Rini wrote: >>> On Mon, May 06, 2019 at 09:26:04AM -0400, Tom Rini wrote: >>> >>>> Hey folks, >>>> >>>> I'm attempting, again, to see what we need to do in order to use gcc-8.x >>>> for U-Boot and ran into, again: >>>> https://patchwork.ozlabs.org/patch/920329/ which in short is that when >>>> using -mcpu=xscale gcc-8.x throws an odd error: >>>> cc1: error: switch -mcpu=xscale conflicts with -march=armv5te switch >>>> [-Werror] >>>> >>>> Now note, U-Boot isn't passing -march= at all, just -mcpu=xscale which >>>> suggests perhaps something broke in upstream gcc. Looking at the >>>> kernel, it's not used -mcpu=xscale ever, just -mtune=xscale but that >>>> leads to different failures (seen here with gcc-7.3): >>>> CC drivers/usb/gadget/pxa25x_udc.o >>>> {standard input}: Assembler messages: >>>> {standard input}:779: Error: selected processor does not support `pld >>>> [lr]' in ARM mode >>>> {standard input}:1201: Error: selected processor does not support `pld >>>> [r7]' in ARM mode >>>> {standard input}:2519: Error: selected processor does not support `pld >>>> [r3]' in ARM mode >>>> {standard input}:2796: Error: selected processor does not support `pld >>>> [r3]' in ARM mode >>>> >>>> So, what should we do about this? Is there still active interest in >>>> supporting the PXA platforms? Thanks folks! >>> >>> ping? Thanks! >> >> Maybe we should just remove it. > > +1, almost no one uses it nowadays.
Well, there are still a few users of Zipit Z2 and there was some interest in Sharp Zaurus, but ... -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
