[U-Boot] [PATCH v4 8/8] pico-imx7d: enable boot without PMIC

[Jun Nie]

If PMIC is not probed successfully, it is still OK to boot
with default configuration although power is not optimized.

Default voltage of SW1A/SW1B is 1.1V/1.0V for PC32PF3000A1EP
on pico according to table 42 of spec of PF3000 ver 9.0.

Default mode of SW1A/SW1B is APS as expected(table 47).

Signed-off-by: Jun Nie <jun....@linaro.org>
---
 board/technexion/pico-imx7d/pico-imx7d.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/board/technexion/pico-imx7d/pico-imx7d.c 
b/board/technexion/pico-imx7d/pico-imx7d.c
index 5b357f2..e3d75e5 100644
--- a/board/technexion/pico-imx7d/pico-imx7d.c
+++ b/board/technexion/pico-imx7d/pico-imx7d.c
@@ -85,8 +85,11 @@ int power_init_board(void)
 
        p = pmic_get("PFUZE3000");
        ret = pmic_probe(p);
-       if (ret)
-               return ret;
+       if (ret) {
+               printf("Warning:  Cannot find PMIC PFUZE3000\n");
+               printf("\tPower consumption is not optimized.\n");
+               return 0;
+       }
 
        pmic_reg_read(p, PFUZE3000_DEVICEID, &reg);
        pmic_reg_read(p, PFUZE3000_REVID, &rev_id);
-- 
2.7.4

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot