On Fri, May 3, 2019 at 7:58 AM Chen-Yu Tsai <w...@kernel.org> wrote: > > From: Chen-Yu Tsai <w...@csie.org> > > Hi everyone, > > This series enables EMAC (Ethernet controller) on two A83T boards, > the Cubietruck Plus and Bananapi M3. > > This series is now based on sunxi/next, which has patches that convert > sun8i-emac to use the common CLK and DM_RESET framework. > > The two patches enable the sun8i-emac and Realtek PHY driver in their > respective defconfigs. The device trees already have the EMAC enabled. > For the Bananapi M3, the regulator providing the I/O voltages is raised > to 3.3V. > > This was tested with the "dhcp" command followed by using the "ping" > command to ping an external IP, in this case 8.8.8.8. > > Regards > ChenYu > > Changes in v3: > - Rebased on sunxi/master > > Changes in v2: > - Dropped clk/reset related changes in favor of DM CLK / RESET support > - Raised DLDO3 for RGMII I/O on Bananapi M3 to 3.3V per design > > Chen-Yu Tsai (2): > sunxi: Enable EMAC on the Cubietruck Plus > sunxi: Enable EMAC on the Bananapi M3
Applied to u-boot-sunxi/master _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot