This failed and caused a boot failure on c201, and afaik
the pins should be setup by the new pinctrl driver.
Signed-off-by: Urja Rannikko <urja...@gmail.com>
---
arch/arm/mach-rockchip/rk3288-board.c | 12 ------------
1 file changed, 12 deletions(-)
diff --git a/arch/arm/mach-rockchip/rk3288-board.c
b/arch/arm/mach-rockchip/rk3288-board.c
index 9c4f7f219f..f5df44dab1 100644
--- a/arch/arm/mach-rockchip/rk3288-board.c
+++ b/arch/arm/mach-rockchip/rk3288-board.c
@@ -321,7 +321,6 @@ int board_early_init_f(void)
{
const uintptr_t GRF_SOC_CON0 = 0xff770244;
const uintptr_t GRF_SOC_CON2 = 0xff77024c;
- struct udevice *pinctrl;
struct udevice *dev;
int ret;
@@ -335,18 +334,7 @@ int board_early_init_f(void)
debug("CLK init failed: %d\n", ret);
return ret;
}
- ret = uclass_get_device(UCLASS_PINCTRL, 0, &pinctrl);
- if (ret) {
- debug("%s: Cannot find pinctrl device\n", __func__);
- return ret;
- }
- /* Enable debug UART */
- ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_UART_DBG);
- if (ret) {
- debug("%s: Failed to set up console UART\n", __func__);
- return ret;
- }
rk_setreg(GRF_SOC_CON2, 1 << 0);
/*
--
2.21.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
