Update README after we switch to use SPL Signed-off-by: Peng Fan <peng....@nxp.com> --- board/freescale/imx8qxp_mek/README | 8 +++++--- include/configs/imx8qxp_mek.h | 2 +- 2 files changed, 6 insertions(+), 4 deletions(-)
diff --git a/board/freescale/imx8qxp_mek/README b/board/freescale/imx8qxp_mek/README index e91e193d11..f32290e3a2 100644 --- a/board/freescale/imx8qxp_mek/README +++ b/board/freescale/imx8qxp_mek/README @@ -39,16 +39,18 @@ $ cp imx-sc-firmware-0.7/mx8qx-mek-scfw-tcm.bin . Build U-Boot ============ - +$ export ATF_LOAD_ADDR=0x80000000 +$ export BL33_LOAD_ADDR=0x80020000 $ make imx8qxp_mek_defconfig -$ make +$ make flash.bin +$ dd if=u-boot.itb of=flash.bin bs=512 seek=528 Flash the binary into the SD card ================================= Burn the flash.bin binary to SD card offset 32KB: -$ sudo dd if=u-boot-dtb.imx of=/dev/sd[x] bs=1024 seek=32 +$ sudo dd if=flash.bin of=/dev/sd[x] bs=1024 seek=32 Boot ==== diff --git a/include/configs/imx8qxp_mek.h b/include/configs/imx8qxp_mek.h index 5372e7f95e..312e30dc6c 100644 --- a/include/configs/imx8qxp_mek.h +++ b/include/configs/imx8qxp_mek.h @@ -10,7 +10,7 @@ #include <asm/arch/imx-regs.h> #ifdef CONFIG_SPL_BUILD -#define CONFIG_SPL_TEXT_BASE 0x100000 +#define CONFIG_SPL_TEXT_BASE 0x0 #define CONFIG_SPL_MAX_SIZE (124 * 1024) #define CONFIG_SYS_MONITOR_LEN (1024 * 1024) #define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR -- 2.14.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
