In spi_flash.c, if CONFIG_SPI_FLASH_BAR is enabled, the function
'clean_bar' makes sure that the Bank Address Register is reset at the
end of functions using it.
However, if this is enabled, those functions may return zero (success)
when they should return an error. This is because after e.g.
'spi_flash_read_common' fails, the return value in 'ret' is overwritten
with the return value of 'clean_bar'.
Fix this by changing 'clean_bar' to take the outer error code into
account and returning its own return value only if the outer error code
is 0.
Signed-off-by: Simon Goldschmidt <simon.k.r.goldschm...@gmail.com>
---
drivers/mtd/spi/spi_flash.c | 21 +++++++++++++++------
1 file changed, 15 insertions(+), 6 deletions(-)
diff --git a/drivers/mtd/spi/spi_flash.c b/drivers/mtd/spi/spi_flash.c
index 0c2392f28a..b13b9f19b7 100644
--- a/drivers/mtd/spi/spi_flash.c
+++ b/drivers/mtd/spi/spi_flash.c
@@ -132,17 +132,26 @@ int spi_flash_cmd_get_sw_write_prot(struct spi_flash
*flash)
*
* Otherwise, the BA24 bit may be left set and then after reset, the
* ROM would read/write/erase SPL from 16 MiB * bank_sel address.
+ *
+ * Since this function is always called, it handles outer error codes
+ * to take care calling functions don't return 0 just because setting
+ * BAR succeeded.
*/
-static int clean_bar(struct spi_flash *flash)
+static int clean_bar(struct spi_flash *flash, int outer_err)
{
+ int ret;
u8 cmd, bank_sel = 0;
if (flash->bank_curr == 0)
- return 0;
+ return outer_err;
cmd = flash->bank_write_cmd;
flash->bank_curr = 0;
- return spi_flash_write_common(flash, &cmd, 1, &bank_sel, 1);
+ ret = spi_flash_write_common(flash, &cmd, 1, &bank_sel, 1);
+ if (outer_err)
+ return outer_err;
+
+ return ret;
}
static int write_bar(struct spi_flash *flash, u32 offset)
@@ -372,7 +381,7 @@ int spi_flash_cmd_erase_ops(struct spi_flash *flash, u32
offset, size_t len)
}
#ifdef CONFIG_SPI_FLASH_BAR
- ret = clean_bar(flash);
+ ret = clean_bar(flash, ret);
#endif
return ret;
@@ -434,7 +443,7 @@ int spi_flash_cmd_write_ops(struct spi_flash *flash, u32
offset,
}
#ifdef CONFIG_SPI_FLASH_BAR
- ret = clean_bar(flash);
+ ret = clean_bar(flash, ret);
#endif
return ret;
@@ -540,7 +549,7 @@ int spi_flash_cmd_read_ops(struct spi_flash *flash, u32
offset,
}
#ifdef CONFIG_SPI_FLASH_BAR
- ret = clean_bar(flash);
+ ret = clean_bar(flash, ret);
#endif
return log_ret(ret);
--
2.17.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
