The comment in uclass-id.h states that
    "U-Boot uclasses start here - in alphabetical order"
but the subsequent list is not sorted alphabetically.
This reestablishes order.

Signed-off-by: Philipp Tomsich <philipp.toms...@theobroma-systems.com>
---

 include/dm/uclass-id.h | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/include/dm/uclass-id.h b/include/dm/uclass-id.h
index c91dca1..aad5d26 100644
--- a/include/dm/uclass-id.h
+++ b/include/dm/uclass-id.h
@@ -29,6 +29,7 @@ enum uclass_id {
        /* U-Boot uclasses start here - in alphabetical order */
        UCLASS_ADC,             /* Analog-to-digital converter */
        UCLASS_AHCI,            /* SATA disk controller */
+       UCLASS_AXI,             /* AXI bus */
        UCLASS_BLK,             /* Block device */
        UCLASS_BOARD,           /* Device information from hardware */
        UCLASS_CLK,             /* Clock source, e.g. used by peripherals */
@@ -38,15 +39,14 @@ enum uclass_id {
        UCLASS_DMA,             /* Direct Memory Access */
        UCLASS_EFI,             /* EFI managed devices */
        UCLASS_ETH,             /* Ethernet device */
+       UCLASS_FIRMWARE,        /* Firmware */
        UCLASS_FS_FIRMWARE_LOADER,              /* Generic loader */
        UCLASS_GPIO,            /* Bank of general-purpose I/O pins */
-       UCLASS_FIRMWARE,        /* Firmware */
        UCLASS_I2C,             /* I2C bus */
        UCLASS_I2C_EEPROM,      /* I2C EEPROM device */
        UCLASS_I2C_GENERIC,     /* Generic I2C device */
        UCLASS_I2C_MUX,         /* I2C multiplexer */
        UCLASS_IDE,             /* IDE device */
-       UCLASS_AXI,             /* AXI bus */
        UCLASS_IRQ,             /* Interrupt controller */
        UCLASS_KEYBOARD,        /* Keyboard input device */
        UCLASS_LED,             /* Light-emitting diode (LED) */
@@ -68,8 +68,8 @@ enum uclass_id {
        UCLASS_PINCONFIG,       /* Pin configuration node device */
        UCLASS_PINCTRL,         /* Pinctrl (pin muxing/configuration) device */
        UCLASS_PMIC,            /* PMIC I/O device */
-       UCLASS_PWM,             /* Pulse-width modulator */
        UCLASS_POWER_DOMAIN,    /* (SoC) Power domains */
+       UCLASS_PWM,             /* Pulse-width modulator */
        UCLASS_PWRSEQ,          /* Power sequence device */
        UCLASS_RAM,             /* RAM controller */
        UCLASS_REGULATOR,       /* Regulator device */
@@ -80,9 +80,9 @@ enum uclass_id {
        UCLASS_SERIAL,          /* Serial UART */
        UCLASS_SMEM,            /* Shared memory interface */
        UCLASS_SPI,             /* SPI bus */
-       UCLASS_SPMI,            /* System Power Management Interface bus */
        UCLASS_SPI_FLASH,       /* SPI flash */
        UCLASS_SPI_GENERIC,     /* Generic SPI flash target */
+       UCLASS_SPMI,            /* System Power Management Interface bus */
        UCLASS_SYSCON,          /* System configuration device */
        UCLASS_SYSRESET,        /* System reset device */
        UCLASS_TEE,             /* Trusted Execution Environment device */
-- 
2.1.4

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot

Reply via email to