After this change the 'eeprom' command can be used with DM aware boards.

Signed-off-by: Lukasz Majewski <lu...@denx.de>

---

 cmd/eeprom.c | 24 +++++++++++++++++++++---
 1 file changed, 21 insertions(+), 3 deletions(-)

diff --git a/cmd/eeprom.c b/cmd/eeprom.c
index 4052cf494a..e88cb131a1 100644
--- a/cmd/eeprom.c
+++ b/cmd/eeprom.c
@@ -137,6 +137,23 @@ static int eeprom_rw_block(unsigned offset, uchar *addr, 
unsigned alen,
                spi_write(addr, alen, buffer, len);
 #else  /* I2C */
 
+#if defined(CONFIG_DM_I2C) && defined(CONFIG_SYS_I2C_EEPROM_BUS)
+       struct udevice *dev;
+
+       ret = i2c_get_chip_for_busnum(CONFIG_SYS_I2C_EEPROM_BUS, addr[0],
+                                     alen - 1, &dev);
+       if (ret) {
+               printf("%s: Cannot find udev for a bus %d\n", __func__,
+                      CONFIG_SYS_I2C_EEPROM_BUS);
+               return CMD_RET_FAILURE;
+       }
+
+       if (read)
+               ret = dm_i2c_read(dev, offset, buffer, len);
+       else
+               ret = dm_i2c_write(dev, offset, buffer, len);
+
+#else /* Non DM I2C support - will be removed */
 #if defined(CONFIG_SYS_I2C_EEPROM_BUS)
        i2c_set_bus_num(CONFIG_SYS_I2C_EEPROM_BUS);
 #endif
@@ -145,10 +162,11 @@ static int eeprom_rw_block(unsigned offset, uchar *addr, 
unsigned alen,
                ret = i2c_read(addr[0], offset, alen - 1, buffer, len);
        else
                ret = i2c_write(addr[0], offset, alen - 1, buffer, len);
-
-       if (ret)
-               ret = 1;
 #endif
+#endif /* CONFIG_DM_I2C && CONFIG_SYS_I2C_EEPROM_BUS */
+       if (ret)
+               ret = CMD_RET_FAILURE;
+
        return ret;
 }
 
-- 
2.11.0

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot

Reply via email to