Hello Marek,
>> From: Ludwig Zenz <lz...@dh-electronics.de>
>>
>> Support 1GIB + 2GIB DDR3 with 64bit bus width and 512MIB + 1GIB with 32bit
>> bus width
>>
>> Signed-off-by: Ludwig Zenz <lz...@dh-electronics.de>
>> ---
>> board/dhelectronics/dh_imx6/dh_imx6_spl.c | 191
>> +++++++++++++++++++++++++++---
>> 1 file changed, 173 insertions(+), 18 deletions(-)
>>
>> diff --git a/board/dhelectronics/dh_imx6/dh_imx6_spl.c
>> b/board/dhelectronics/dh_imx6/dh_imx6_spl.c
> [...]
>
> This patch causes memory instability on 1GiB MX6Q part.
>
> Can you check that and fix it ? Thanks.
Can you tell me more about the error? How do you test this? Did you run a git
bisect?
We did tests in a climate chamber with this configuration (with the MX6Q and
all others).
I think there is only one change that could make a difference:
static const struct mx6_ddr3_cfg dhcom_mem_ddr_2g = {
...
- .trcd = 1312,
+ .trcd = 1375,
....
Best Regards,
Ludwig Zenz
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
