On 3 September 2018 at 18:05, Jagdish Gediya <jagdish.ged...@nxp.com> wrote:
> Below is the sequence to embed dtb inside U-Boot,
> 1. Remove bootpg and resetvec section if needed
> 2. Append dtb
> 3. Append bootpg and resetvec section back if removed in step 1
>
> Above procedure is required only when CONFIG_MPC85xx and
> CONFIG_OF_SEPARATE are defined.
>
> Add new config CONFIG_MPC85XX_HAVE_RESET_VECTOR to indicate that
> image has resetvec section. Step 1 and step 3 described above are
> required only if this config is y.
>
> Signed-off-by: Jagdish Gediya <jagdish.ged...@nxp.com>
> ---
> Changes for v2:
> - Don't change the generic target
> - Add new config option to use binman
Where is that config option? I don't see it in this patch.
>
> Changes for v3:
> - Commit message change('u-boot' -> 'U-Boot')
>
> Makefile | 23 ++++++++++++++++++++++-
> arch/powerpc/cpu/mpc85xx/Kconfig | 4 ++++
> 2 files changed, 26 insertions(+), 1 deletion(-)
Reviewed-by: Simon Glass <s...@chromium.org>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
