On Sat, 2018-06-23 at 06:23 +0200, Marek Vasut wrote: > On 06/23/2018 05:55 AM, Marek Vasut wrote: > > > > On 06/06/2018 08:47 PM, Marek Vasut wrote: > > > > > > On 05/31/2018 12:00 PM, Marek Vasut wrote: > > > > > > > > On 05/31/2018 11:52 AM, See, Chin Liang wrote: > > > > > > > > > > On Tue, 2018-05-29 at 18:39 +0200, Marek Vasut wrote: > > > > > > > > > > > > Make sure the ARM ACTLR register has correct configuration, > > > > > > otherwise > > > > > > the Linux kernel refuses to boot. In particular, the "Write > > > > > > Full Line > > > > > > of Zeroes" bit must be cleared. > > > > > > > > > > > > Signed-off-by: Marek Vasut <ma...@denx.de> > > > > > > Cc: Chin Liang See <chin.liang....@intel.com> > > > > > > Cc: Dinh Nguyen <dingu...@kernel.org> > > > > > > --- > > > > > > NOTE: This gem was well hidden in the Altera U-Boot fork > > > > > > and is > > > > > > really needed. > > > > > > What is not entirely clear to me is WHY ? So why is > > > > > > this needed > > > > > > ? > > > > > I vaguely recall it's related to HW constrain. And check back > > > > > the > > > > > downstream U-Boot, actually we need to set the bit instead > > > > > clearing > > > > > it. https://github.com/altera-opensource/u-boot-socfpga/blob/ > > > > > socfpga_v2 > > > > > 014.10_arria10_bringup/arch/arm/cpu/armv7/socfpga_arria10/pl3 > > > > > 10.c > > > > You are clearing it here: > > > > https://github.com/altera-opensource/u-boot-socfpga/blob/socfpg > > > > a_v2014.10_arria10_bringup/arch/arm/cpu/armv7/socfpga_arria10/l > > > > owlevel_init.S#L35 > > > > > > > > The PL310 configuration is a different register. What HW > > > > constraint ? > > > > I'd really like to understand this problem. > > > Bump ? I had a report the register even has to be set to 0 , > > > otherwise > > > there are ethernet problems. What is going on with this register > > > ? > > Bump again ? > > > Expanding the CC list. I am tempted to stop accepting any socfpga > patches until this is resolved. >
Just realize this is not addressed as Ley Foon talked to me We checked with HW team that the full line of zeroes is a special setup of signals between A9 and L2 cache controller. As they recalled that this signal is not 100% AXI compliance, it may hang the system if L2 cache is disabled while full line of zeroes is set. In A10, one thing new is we enabled L2 cache in BootROM and this bit is set. When entering the U-Boot, we are ensuring all cache are disabled. At this point, we need to ensure full line of zeroes bit is cleared. Only when U-Boot renable the cache including L2, this bit is set again. Hope this explains. Thanks Chin Liang _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot