Hi Miquel, On 2 May 2018 at 02:59, Miquel Raynal <miquel.ray...@bootlin.com> wrote: > On some designs, the reset line could not be connected to the SoC reset > line, in this case, request the GPIO and ensure the chip gets reset. > > Signed-off-by: Miquel Raynal <miquel.ray...@bootlin.com> > --- > drivers/tpm/tpm2_tis_spi.c | 18 ++++++++++++++++++ > 1 file changed, 18 insertions(+) > > diff --git a/drivers/tpm/tpm2_tis_spi.c b/drivers/tpm/tpm2_tis_spi.c > index cfef5b8c24..824ab70bae 100644 > --- a/drivers/tpm/tpm2_tis_spi.c > +++ b/drivers/tpm/tpm2_tis_spi.c > @@ -24,6 +24,9 @@ > #include <linux/compiler.h> > #include <linux/types.h> > #include <linux/unaligned/be_byteshift.h> > +#ifdef CONFIG_DM_GPIO > +#include <asm-generic/gpio.h> > +#endif > > #include "tpm_tis.h" > #include "tpm_internal.h" > @@ -598,6 +601,21 @@ static int tpm_tis_spi_probe(struct udevice *dev) > { > struct tpm_chip *chip = dev_get_priv(dev); > int ret; > +#ifdef CONFIG_DM_GPIO > + struct gpio_desc reset_gpio; > + > + ret = gpio_request_by_name(dev, "gpio-reset", 0, > + &reset_gpio, GPIOD_IS_OUT); > + if (ret) > + log(LOGC_NONE, LOGL_NOTICE, "%s: missing reset GPIO\n", > + __func__); > + > + if (dm_gpio_is_valid(&reset_gpio)) {
If ret is 0 you know the GPIO is valid, so just check ret. > + dm_gpio_set_value(&reset_gpio, 0); > + mdelay(1); > + dm_gpio_set_value(&reset_gpio, 1); > + } > +#endif > > /* Ensure a minimum amount of time elapsed since reset */ > mdelay(30); > -- > 2.14.1 > Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot