On Fri, 2018-04-20 at 03:16 +0000, Prabhakar Kushwaha wrote: > Thanks Scott for reviewing this patch > > > -----Original Message----- > > From: U-Boot [mailto:u-boot-boun...@lists.denx.de] On Behalf Of Scott > > Wood > > Sent: Friday, April 20, 2018 6:40 AM > > To: Calvin Johnson <linux...@gmail.com> > > Cc: U-Boot Mailing List <u-boot@lists.denx.de> > > Subject: Re: [U-Boot] [PATCH] board: freescale: ls1012ardb: Add command to > > switch QSPI bank > > > > On Thu, 2018-04-19 at 14:09 +0530, Calvin Johnson wrote: > > > On Thu, Apr 19, 2018 at 12:17 PM, Scott Wood <o...@buserror.net> wrote: > > > > On Mon, 2018-04-16 at 08:40 +0530, Calvin Johnson wrote: > > > > > On Fri, Apr 13, 2018 at 12:18 AM, Jagdish Gediya > > > > > <jagdish.ged...@nxp.com > > > > > > > > > > > > > > > > wrote: > > > > > > Add command "boot_bank X" to switch the boot bank to either > > > > > > 1 or 2. > > > > > > > > > > Are these functions required as this can be handled by new env > > > > > vars to switch banks? > > > > > > > > If you're going to add something new, a command is much more > > > > pleasant than env vars -- particularly if you stick to something > > > > like the familiar interfaces ("pix altbank", "qix altbank", etc), > > > > and include reporting of which bank was booted from if it's not > > > > there already. Of course, a fully standardized interface would be > > > > even better. > > > > > > Yes, a fully standardized generic interface supporting all similar > > > platforms with multiple banks > > > > And other boot sources such as NAND and MMC. > > > LS1012A has only one boot source i.e. QSPI
I meant that if there is any effort to standardize the command it should support multiple boot sources, not just bank selection. -Scott _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
