On 03/16/2018 01:26 AM, Mike Looijmans wrote:
On 15-03-18 02:36, David Lechner wrote:commit 1601dd97edc6 ("davinci: omapl138_lcdk: increase PLL0 frequency") changed the PLL0 frequency to 456MHz, which is needed for the LCDC IP block. However, in doing so, it caused the PLLOUT clock to be outside of the allowable specifications given in the OMAP-L138 data sheet. (It says PLLOUT must be 600MHz max). It also uses a PLLM value outside of the range given in the TRM (it says PLLM must in the range 0 to 0x1f). So here is what we have currently: PLLOUT = 24 / (0 + 1) * (37 + 1) = 912MHz (out of spec) ^ ^ ^ CLKIN PREDIV PLLM (out of spec) input to PLLDIVn = 912 / (1 + 1) = 456MHz (desired result) ^ ^ PLLOUT POSTDIV This changes the PLLM value to 18 and the POSTDIV value to 0 so that PLLOUT is now within specification but we still get the desired result. PLLOUT = 24 / (0 + 1) * (18 + 1) = 456MHz (within spec) ^ ^ ^ CLKIN PREDIV PLLM input to PLLDIVn = 456 / (0 + 1) = 456MHz (desired result) ^ ^ PLLOUT POSTDIVThese are indeed the correct settings for 456MHz operation, I've used them in an L138 device a few years ago. Did you also increase the CPU voltage to 1.3V? This can be done writing to the I2C power management chip, in my stone age setup I had this piece of code to do that: #define TPS6507X_I2C_ADDR 0x48 #define TPS6507X_REG_DEFLDO2 0x17 u8 buf = 0x17; i2c_write(TPS6507X_I2C_ADDR, TPS6507X_REG_DEFLDO2, 1, &buf, 1) Without the voltage change, some batches of CPUs will fail to boot properly at 456MHz.
I was wondering about this, but it looks to me like the LCDK board (at least the A7E revision) has a fixed regulator at 1.3V (TPS650250RHBR). Perhaps you are using a different board? _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
