Khasim Syed Mohammed wrote:
> From 977856ac122e451a8de195d9f22253196572157a Mon Sep 17 00:00:00 2001
> From: Syed Mohammed Khasim <kha...@ti.com>
> Date: Tue, 12 Jan 2010 16:32:42 +0530
> Subject: [PATCH] Add support for 720Mhz
>
> A New API to allow setting M value to support 720Mhz
>
> Signed-off-by: Syed Mohammed Khasim <kha...@ti.com>
> ---
> cpu/arm_cortexa8/omap3/clock.c | 21 +++++++++++++++++++++
> 1 files changed, 21 insertions(+), 0 deletions(-)
>
> diff --git a/cpu/arm_cortexa8/omap3/clock.c b/cpu/arm_cortexa8/omap3/clock.c
> index 174c453..d67517a 100644
> --- a/cpu/arm_cortexa8/omap3/clock.c
> +++ b/cpu/arm_cortexa8/omap3/clock.c
> @@ -402,3 +402,24 @@ void per_clocks_enable(void)
>
> sdelay(1000);
> }
> +
> +/*
> + * Configure PRCM registers to get 720 Mhz
> + *
> + * NOTE: N value doesn't change, only M gets affected
> + */
> +void prcm_config_720mhz(void)
> +{
Generalize this
Change the name prcm_config.
Possiblly pass in an enum for supported clk.
Setting the omap clk is not this simple.
It is dependent on at least the input frequency.
I do not see where this is checked here.
You should rethink how this is being done.
Move this to the beagle board dir.
Tom
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
