Scott Wood wrote: > On Thu, Nov 05, 2009 at 08:53:36AM +0000, > kevin.morf...@fearnside-systems.co.uk wrote: >> This patch updates the s3c2410 nand driver from that of linux 2.6.31.5, >> modified to make it work in the u-boot mtd nand architecture and to allow >> setting the flash timing parameters from a board config file instead of >> being hard coded. Note that this modified driver supports s3c2410 and >> s3c2440. >> >> Signed-off-by: Kevin Morfitt <kevin.morf...@fearnside-systems.co.uk> >> --- >> >> checkpatch.pl shows no errors or warnings, and MAKEALL ARM9 shows no new >> errors or warnings. >> >> Tested on an Embest SBC2440-II Board with local s3c2440 patches as I don't >> have an s3c2410 board. >> >> drivers/mtd/nand/s3c2410_nand.c | 134 >> +++++++++++++++++-------------- >> include/asm-arm/arch-s3c24x0/s3c2410.h | 25 ++++++ >> 2 files changed, 98 insertions(+), 61 deletions(-) > > It looks like this got missed, probably because it either depended on > something in (or destined for) the ARM tree, or I just assumed that because > of the "PATCH ARM". > > Unfortunately, it doesn't apply cleanly anymore. Could you resend, if it's > still needed?
It was part of adding s3c2440 support which I've had to re-work quite a lot and is currently waiting for comments on a set of re-worked patches. I think it would be simpler if I dropped this one and submitted a replacement later on. I think the s3c2410 nand driver code is different in the u-boot main, Samsung SOC, and NAND repositories though so I'm not sure what I should base a future patch on given that Wolfgang asked me to always base patches on u-boot master. > > -Scott > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
