We are switching to a model where our board file can directly fail probing
of serial devices when they're not usable, so remove the current runtime
hack we have.
Signed-off-by: Alexander Graf <ag...@suse.de>
---
board/raspberrypi/rpi/rpi.c | 43 -------------------------------------------
1 file changed, 43 deletions(-)
diff --git a/board/raspberrypi/rpi/rpi.c b/board/raspberrypi/rpi/rpi.c
index c8924d4362..177f4af265 100644
--- a/board/raspberrypi/rpi/rpi.c
+++ b/board/raspberrypi/rpi/rpi.c
@@ -420,54 +420,11 @@ static void get_board_rev(void)
printf("RPI %s (0x%x)\n", model->name, revision);
}
-#ifndef CONFIG_PL01X_SERIAL
-static bool rpi_is_serial_active(void)
-{
- int serial_gpio = 15;
- struct udevice *dev;
-
- /*
- * The RPi3 disables the mini uart by default. The easiest way to find
- * out whether it is available is to check if the RX pin is muxed.
- */
-
- if (uclass_first_device(UCLASS_PINCTRL, &dev) || !dev)
- return true;
-
- if (pinctrl_get_gpio_mux(dev, 0, serial_gpio) != BCM2835_GPIO_ALT5)
- return false;
-
- return true;
-}
-
-/* Disable mini-UART I/O if it's not pinmuxed to our pins.
- * The firmware only enables it if explicitly done in config.txt: enable_uart=1
- */
-static void rpi_disable_inactive_uart(void)
-{
- struct udevice *dev;
- struct bcm283x_mu_serial_platdata *plat;
-
- if (uclass_get_device_by_driver(UCLASS_SERIAL,
- DM_GET_DRIVER(serial_bcm283x_mu),
- &dev) || !dev)
- return;
-
- if (!rpi_is_serial_active()) {
- plat = dev_get_platdata(dev);
- plat->disabled = true;
- }
-}
-#endif
-
int board_init(void)
{
#ifdef CONFIG_HW_WATCHDOG
hw_watchdog_init();
#endif
-#ifndef CONFIG_PL01X_SERIAL
- rpi_disable_inactive_uart();
-#endif
get_board_rev();
--
2.12.3
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
