On Fri, Jan 5, 2018 at 1:06 PM, Jun Nie <jun....@linaro.org> wrote: > Add Bananapi Zero board defconfig and device tree. > OTG device is supported with enabling clock and adding necessary > controller configuration change. USB mass storage is tested as > a test case. > > Jun Nie (6): > sunxi: h3: add usb_otg and OHCI/EHCI for usbc0 on H3 > sunxi: musb: Add fifo config for H3 > sunxi: musb: Enable OTG device clock for H3 > sunxi: musb: Hack dynamic fifo support for H3 OTG > sunxi: usb_phy: Clear PHYCTL register before writing
a64 on otg have in ML[1] check if any redundant otherwise it's OK., we will test these and send next version. > sunxi: Add initial Banana-Pi Zero support similar patch is already in ML [2] [1] https://patchwork.ozlabs.org/cover/847375/ [2] https://patchwork.ozlabs.org/patch/832937/ -- Jagan Teki Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream Maintainer Hyderabad, India. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
