>>> I'm seeing some issues with some of the i.MX6 devices with the latest >>> stable release. It loads the SPL and then just seems to loop: >>> >>> U-Boot SPL 2017.09 (Sep 25 2017 - 18:42:10) >>> Trying to boot from MMC1 >>> >>> U-Boot SPL 2017.09 (Sep 25 2017 - 18:42:10) >>> Trying to boot from MMC1 >>> >>> U-Boot SPL 2017.09 (Sep 25 2017 - 18:42:10) >>> Trying to boot from MMC1 >>> >>> This is built on Fedora with latest gcc7 so I'm not sure if that's a >>> possible issue. Is this something people are aware of and I've missed >>> the fix. >> >> I haven't tested it with gcc7 yet, but if I use gcc6 I do not see the >> problem: >> >> U-Boot SPL 2017.09 (Sep 25 2017 - 15:55:59) >> Trying to boot from MMC1 >> >> >> U-Boot 2017.09 (Sep 25 2017 - 15:55:59 -0300) >> >> CPU: Freescale i.MX6Q rev1.2 at 792 MHz >> Reset cause: POR >> Board: Wandboard rev B1 >> I2C: ready >> DRAM: 2 GiB >> MMC: FSL_SDHC: 0, FSL_SDHC: 1 >> No panel detected: default to HDMI >> Display: HDMI (1024x768) >> In: serial >> Out: serial >> Err: serial >> Net: FEC [PRIME] >> Hit any key to stop autoboot: 0 >> => >> >> So maybe this issue could be related to gcc7? > > I've tested building U-Boot for Wandboard using GCC 7 from linaro.org: > https://releases.linaro.org/components/toolchain/binaries/
I tested a build with 6.4 from Fedora 25 and I saw the same issue so I'm not sure where the problem is coming from but I'm also travelling/meetings so haven't had time to dig further into the issue _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot