Hi, I am trying to run the master on a STM32F746 Discovery board [1] by using stm32f746-disco_defconfig. It was built with gcc-arm-none-eabi-5_4-2016q3 [2] and flashed with OpenOCD [3]. A USB-serial adapter is connected to USART6_RX and USART6_TX (pins D0 and D1 of the Arduino connector) and configured for 115200 8N1. No output coming out through the serial interface. It is unlikely to be a hardware issue as output is coming out normally this way when using the U-Boot repository from Emcraft.
I do not know what I am doing wrong, can you help me out? Cheers, Francois [1] http://www.st.com/en/evaluation-tools/32f746gdiscovery.html [2] https://launchpad.net/gcc-arm-embedded [3] http://openocd.org [4] https://github.com/EmcraftSystems/u-boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
