LS2080ARDB/LS2088ARDB updated RevF boards do not have
smart voltage translator, so no need to program GPIO
for LS2088ARDB boards
The GPIO programming is required only for LS2081ARDB.
Signed-off-by: Santan Kumar <santan.ku...@nxp.com>
Signed-off-by: Priyanka Jain <priyanka.j...@nxp.com>
---
board/freescale/ls2080ardb/ls2080ardb.c | 18 ++----------------
1 file changed, 2 insertions(+), 16 deletions(-)
diff --git a/board/freescale/ls2080ardb/ls2080ardb.c
b/board/freescale/ls2080ardb/ls2080ardb.c
index df2d768..210142c 100644
--- a/board/freescale/ls2080ardb/ls2080ardb.c
+++ b/board/freescale/ls2080ardb/ls2080ardb.c
@@ -257,31 +257,17 @@ int board_early_init_f(void)
int misc_init_r(void)
{
-#ifdef CONFIG_FSL_QIXIS
- /*
- * LS2081ARDB has smart voltage translator which needs
- * to be programmed as below
- */
-#ifndef CONFIG_TARGET_LS2081ARDB
- u8 sw;
-
- sw = QIXIS_READ(arch);
/*
- * LS2080ARDB/LS2088ARDB RevF board has smart voltage translator
+ * LS2081ARDB RevF board has smart voltage translator
* which needs to be programmed to enable high speed SD interface
* by setting GPIO4_10 output to zero
*/
- if ((sw & 0xf) == 0x5) {
-#endif
+#ifdef CONFIG_TARGET_LS2081ARDB
out_le32(GPIO4_GPDIR_ADDR, (1 << 21 |
in_le32(GPIO4_GPDIR_ADDR)));
out_le32(GPIO4_GPDAT_ADDR, (~(1 << 21) &
in_le32(GPIO4_GPDAT_ADDR)));
-#ifndef CONFIG_TARGET_LS2081ARDB
- }
-#endif
#endif
-
if (hwconfig("sdhc"))
config_board_mux(MUX_TYPE_SDHC);
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
