On Mon, May 08, 2017 at 10:14:23PM -0400, Tom Rini wrote:
>The variable usdhc1_pads is only referenced during SPL builds, add a
>guard.
>
>Cc: Fabio Estevam <fabio.este...@nxp.com>
>Cc: Peng Fan <peng....@nxp.com>
>Cc: Stefano Babic <sba...@denx.de>
>Signed-off-by: Tom Rini <tr...@konsulko.com>
Reviewed-by: Peng Fan <peng....@nxp.com>
>---
> board/freescale/mx6slevk/mx6slevk.c | 2 ++
> 1 file changed, 2 insertions(+)
>
>diff --git a/board/freescale/mx6slevk/mx6slevk.c
>b/board/freescale/mx6slevk/mx6slevk.c
>index d49543315b92..228514b106a8 100644
>--- a/board/freescale/mx6slevk/mx6slevk.c
>+++ b/board/freescale/mx6slevk/mx6slevk.c
>@@ -66,6 +66,7 @@ static iomux_v3_cfg_t const uart1_pads[] = {
> MX6_PAD_UART1_RXD__UART1_RXD | MUX_PAD_CTRL(UART_PAD_CTRL),
> };
>
>+#ifdef CONFIG_SPL_BUILD
> static iomux_v3_cfg_t const usdhc1_pads[] = {
> /* 8 bit SD */
> MX6_PAD_SD1_CLK__USDHC1_CLK | MUX_PAD_CTRL(USDHC_PAD_CTRL),
>@@ -106,6 +107,7 @@ static iomux_v3_cfg_t const usdhc3_pads[] = {
> /*CD pin*/
> MX6_PAD_REF_CLK_32K__GPIO_3_22 | MUX_PAD_CTRL(NO_PAD_CTRL),
> };
>+#endif
>
> static iomux_v3_cfg_t const fec_pads[] = {
> MX6_PAD_FEC_MDC__FEC_MDC | MUX_PAD_CTRL(ENET_PAD_CTRL),
>--
>1.9.1
>
>_______________________________________________
>U-Boot mailing list
>U-Boot@lists.denx.de
>https://lists.denx.de/listinfo/u-boot
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
