On Wed, 28 Oct 2009 14:19:18 +0530 Sandeep Gopalpet <sandeep.ku...@freescale.com> wrote:
> Moved the mdio regs out of the tsec structure,and > provided different offsets for tsec base and mdio > base so that provision for etsec2.0 can be provided. > > This patch helps in providing the support for etsec2.0 > In etsec2.0, the MDIO register space and the etsec reg > space are different. > > Also, moved the TSEC_BASE_ADDR and MDIO_BASE_ADDR definitons into > platform specific files. > > Signed-off-by: Sandeep Gopalpet <sandeep.ku...@freescale.com> > --- without this patchseries: U-Boot 2009.11-rc1 (Oct 28 2009 - 14:57:54) MPC83XX Reset Status: Software Hard, External/Internal Soft, External/Internal Hard CPU: e300c3, MPC8315E, Rev: 1.0 at 400 MHz, CSB: 133.333 MHz Board: Freescale MPC8315ERDB Rev 0.1 I2C: ready DRAM: 128 MB FLASH: 8 MB NAND: 32 MiB PCIE0: No link PCIE1: No link In: serial Out: serial Err: serial Net: eTSEC0, eTSEC1 Hit any key to stop autoboot: 0 => ping $serverip Speed: 1000, full duplex Using eTSEC0 device host 192.168.1.1 is alive => with this patchseries: U-Boot 2009.11-rc1-00002-g3775d27 (Oct 28 2009 - 14:45:51) MPC83XX Reset Status: Software Hard, External/Internal Soft, External/Internal Hard CPU: e300c3, MPC8315E, Rev: 1.0 at 400 MHz, CSB: 133.333 MHz Board: Freescale MPC8315ERDB Rev 0.1 I2C: ready DRAM: 128 MB FLASH: 8 MB NAND: 32 MiB PCIE0: No link PCIE1: No link In: serial Out: serial Err: serial Net: eTSEC0: No support for PHY id 0; assuming generic eTSEC1: No support for PHY id 0; assuming generic eTSEC0, eTSEC1 Hit any key to stop autoboot: 0 => ping $serverip eTSEC0: No link. eTSEC1: No link. ping failed; host 192.168.1.1 is not alive do you not test older version tsecs/83xx? > +typedef struct tsec_mdio > +{ please also move this brace onto the above line. Kim _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot