Hi Fabio, On Wed, Mar 1, 2017 at 7:46 PM, Fabio Estevam <feste...@gmail.com> wrote: > Hi Jagan, > > On Wed, Mar 1, 2017 at 9:55 AM, Jagan Teki <ja...@openedev.com> wrote: >> + ML >> >> On Wed, Mar 1, 2017 at 6:23 PM, Jagan Teki <ja...@openedev.com> wrote: >>> Hi Peng and All, >>> >>> I'm trying to boot from SD, on imx6qplus sabre board. >>> >>> - SW6: D1-D8 => 0100 0010 >>> - SD card on SD3 >>> - D12 with USB-to-Serial 115200 8N1 >>> - Power supply Output 5V >>> >>> Build: >>> $ make mx6qpsabreauto_defconfig; make >>> $ dd if=u-boot.imx of=/dev/sda bs=512 seek=2 > > I don't have a imx6qp sabresd board handy, but can you try the SPL > config instead? > > make mx6sabresd_spl_defconfig > dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync > dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync > > It worked for me the last time I tried it with mainline U-Boot.
Yes, able to boot with SPL config. U-Boot SPL 2017.03-rc3 (Mar 01 2017 - 20:46:00) Trying to boot from MMC1 U-Boot 2017.03-rc3 (Mar 01 2017 - 20:46:00 +0530) CPU: Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz) CPU: Automotive temperature grade (-40C to 125C) at 35C Reset cause: POR Board: MX6-SabreSD I2C: ready DRAM: 1 GiB PMIC: PFUZE100 ID=0x10 MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2 *** Warning - bad CRC, using default environment PCI: pcie phy link never came up No panel detected: default to Hannstar-XGA Display: Hannstar-XGA (1024x768) In: serial Out: serial Err: serial Net: FEC [PRIME] Hit any key to stop autoboot: 0 => thanks! -- Jagan Teki Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream Maintainer Hyderabad, India. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/listinfo/u-boot
