> -----Original Message-----
> From: york sun
> Sent: Thursday, December 08, 2016 12:03 AM
> To: Y.B. Lu; u-boot@lists.denx.de
> Subject: Re: [PATCH 2/2] armv8: ls1012a: define esdhc_status_fixup for
> QDS board
>
> On 12/07/2016 12:34 AM, Yangbo Lu wrote:
> > The LS1012AQDS board has a hardware issue. When there is no eMMC
> > adapter card inserted, the command inhibit bits of eSDHC_PRSSTAT
> > register will never release. This would cause below continious error
> > messages in linux since it uses polling mode to detect card.
> > "mmc1: Controller never released inhibit bit(s)."
> > "mmc1: Controller never released inhibit bit(s)."
> > "mmc1: Controller never released inhibit bit(s)."
> > This patch is to define esdhc_status_fixup function to disable eSDHC2
> > status if no eMMC adapter card is detected.
> >
> > Signed-off-by: Yangbo Lu <yangbo...@nxp.com>
> > ---
> > board/freescale/ls1012aqds/ls1012aqds.c | 19 +++++++++++++++++++
> > 1 file changed, 19 insertions(+)
> >
> > diff --git a/board/freescale/ls1012aqds/ls1012aqds.c
> > b/board/freescale/ls1012aqds/ls1012aqds.c
> > index 94440b3..a3229f7 100644
> > --- a/board/freescale/ls1012aqds/ls1012aqds.c
> > +++ b/board/freescale/ls1012aqds/ls1012aqds.c
> > @@ -121,6 +121,25 @@ int board_eth_init(bd_t *bis)
> > return pci_eth_init(bis);
> > }
> >
> > +int esdhc_status_fixup(void *blob, const char *compat) {
> > + char esdhc0_path[] = "/soc/esdhc@1560000";
> > + char esdhc1_path[] = "/soc/esdhc@1580000";
> > + u8 card_id;
> > +
> > + do_fixup_by_path(blob, esdhc0_path, "status", "okay",
> > + sizeof("okay"), 1);
> > +
>
> This controller is always "okay", isn't it?
[Lu Yangbo-B47093] Yes. Only sdhc2 has issue. I will emphasize it's sdhc2 in
commit message.
>
> > + card_id = (QIXIS_READ(present2) & 0xe0) >> 5;
> > +
> > + if (card_id == 0x7)
>
> Please put a comment here to explain what present2 has and what 0x7 is.
[Lu Yangbo-B47093] No problem, thanks. Will send the v2.
>
> > + do_fixup_by_path(blob, esdhc1_path, "status", "disabled",
> > + sizeof("disabled"), 1);
> > + else
> > + do_fixup_by_path(blob, esdhc1_path, "status", "okay",
> > + sizeof("okay"), 1);
> > +}
> > +
>
> York
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
