On Wed, Nov 30, 2016 at 8:30 AM, Simon Glass <s...@chromium.org> wrote: > At present an invalid bus width prints a message but does not return an > error. This is the opposite of the correct behaviour. Adjust it to avoid > code bloat in the common case, and avoid hard-to-debug failure in the > uncommon case. > > Signed-off-by: Simon Glass <s...@chromium.org> > --- > > Changes in v3: > - Display an error in U-Boot proper, but then continue > - Drop patches previously applied > > drivers/spi/spi-uclass.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/spi/spi-uclass.c b/drivers/spi/spi-uclass.c > index f59a701..1ab5b75 100644 > --- a/drivers/spi/spi-uclass.c > +++ b/drivers/spi/spi-uclass.c > @@ -418,7 +418,7 @@ int spi_slave_ofdata_to_platdata(const void *blob, int > node, > mode |= SPI_TX_QUAD; > break; > default: > - error("spi-tx-bus-width %d not supported\n", value); > + warn_non_spl("spi-tx-bus-width %d not supported\n", value);
I thought in SPL it will reverse like debug and return by error, make sense? thanks! -- Jagan Teki Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream Maintainer Hyderabad, India. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot