Am Dienstag 29 September 2009 15:55:55 schrieb Dieter Kiermaier: > Hi everybody, > > I try to bring up fw_setenv / fw_printenv in linux kernel but first it want > to start with u-boot itself. > I built most recent u-boot-marvell git source and get a running u-boot with > standard openrd configuration. > So far so good. >
Hm, it looks like there is the whole nand system somewhat broken :( Haven't seen it earlier, but: U-Boot 2009.08-00208-g9ef0569-dirty (Sep 29 2009 - 15:42:42) OpenRD_base SoC: Kirkwood 88F6281_A0 DRAM: 27535155593740288 MB NAND: 0 MiB *** Warning - bad CRC or NAND, using default environment In: serial Out: serial Err: serial Net: egiga0 88E1116 Initialized on egiga0 But boot message state that there is no NAND detected! So I assume that is the main cause for the not working saveenv command? Cross checked it with marvell provided u-boot - this one works. So damaged hardware isn't the case. Please could somebody check it, too? Many thanks, Dieter > version says: > ArtistaNET-III>> version > > U-Boot 2009.08-00208-g9ef0569-dirty (Sep 29 2009 - 15:42:42) > OpenRD_base > > > But saveenv will not work as expected. setenv of new parameter will work but > after saveenv and reboot > the new parameter is lost and u-boot complains about wrong CRC again. > > Any help would be very appreciated. > > Dieter > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
