Hi On 10/11/2016 11:08 PM, Oscar Gomez Fuente wrote: > Hi everyone, > > I've just compiled u-boot for a picoZed platform with > the zynq_picozed_defconfig, and I've realised that the NET and SD Card > aren't recognised. In the init I see these messages: > > I boot from the SD Card and I see these messages from my uart terminal: > > --------------------- > U-Boot 2016.11-rc1-00139-gf5fd45f (Oct 11 2016 - 15:48:54 +0200) > > Model: Zynq PicoZed Board > Board: Xilinx Zynq > DRAM: ECC disabled 1 GiB > MMC: > Using default environment > > In: serial@e0001000 > Out: serial@e0001000 > Err: serial@e0001000 > Model: Zynq PicoZed Board > Board: Xilinx Zynq > Net: No ethernet found. > ** Bad device mmc 0 ** > Checking if uenvcmd is set ... > Hit any key to stop autoboot: 0 > --------------------- > > So, I think something has broken. Could anyone chek this issue?
Could you enable the CONFIG_MMC_TRACE? then we can see more information. And which config do you use? Best Regards, Jaehoon Chung > > > Thank you very much. Best regards. > > Oscar Gomez Fuente > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot > > > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
