The loop to set up buffer addresses in rx descriptors always operated on
descriptor 0, rather than on each descriptor sequentially. Fix this in
order to setup correct buffer addresses for each descriptor.
Signed-off-by: Paul Burton <paul.bur...@imgtec.com>
---
drivers/net/pch_gbe.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/pch_gbe.c b/drivers/net/pch_gbe.c
index 4aac0f6..e41d737 100644
--- a/drivers/net/pch_gbe.c
+++ b/drivers/net/pch_gbe.c
@@ -117,8 +117,8 @@ static void pch_gbe_rx_descs_init(struct udevice *dev)
memset(rx_desc, 0, sizeof(struct pch_gbe_rx_desc) * PCH_GBE_DESC_NUM);
for (i = 0; i < PCH_GBE_DESC_NUM; i++)
- rx_desc->buffer_addr = dm_pci_phys_to_mem(priv->dev,
- (ulong)(priv->rx_buff[i]));
+ rx_desc[i].buffer_addr = dm_pci_virt_to_mem(priv->dev,
+ priv->rx_buff[i]);
writel(dm_pci_phys_to_mem(priv->dev, (ulong)rx_desc),
&mac_regs->rx_dsc_base);
--
2.10.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
