+Glaucio who is facing the same problem but on a cubieboard2. On Sun, 21 Aug 2016 16:14:39 +0200 Boris Brezillon <boris.brezil...@free-electrons.com> wrote:
> Hi, > > On Sun, 21 Aug 2016 12:03:19 +0200 > Hans de Goede <hdego...@redhat.com> wrote: > > > Hi, > > > > On 21-08-16 11:01, Marcus Glocker wrote: > > > On Sat, Aug 20, 2016 at 03:05:38PM -0400, Tom Rini wrote: > > > > > >> On Sat, Aug 20, 2016 at 07:26:19AM +0200, Marcus Glocker wrote: > > >>> Hello, > > >>> > > >>> While U-Boot SPL 2015.10 works fine on my allwinner,sun5i-r8 board I > > >>> face following issue with U-Boot SPL 2016.09-rc1 on it: > > >>> > > >>> bash-4.3# cu -l /dev/cuaU0 -s 115200 > > >>> Connected to /dev/cuaU0 (speed 115200) > > >>> > > >>> U-Boot SPL 2016.09-rc1 (Jul 31 2016 - 16:37:00) > > >>> DRAM: 512 MiB > > >>> CPU: 1008000000Hz, AXI/AHB/APB: 3/2/2 > > >>> Trying to boot from NAND > > >>> ### ERROR ### Please RESET the board ### > > >>> > > >>> Any ideas what change did cause this or where to start looking after? > > >>> > > Markus, can you share your .config? > I tested the different bits while submitting the NAND driver and the > SPL NAND driver improvements and it was working fine. > I'll try to test 2016.09-rc1 tomorrow. Just tried to boot a mainline uboot on my CHIP and it boots fine [1]. Here is my .config [2], can you compare yours with this one? Can you also detail how you flash the images? Thanks, Boris [1]http://code.bulix.org/xr8n68-105114 [2]http://code.bulix.org/hft09x-105116 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
