Hi Diego, On 08/08/2016 18:12, Diego Dorta wrote: > Hi Stefano, > > I downloaded the patch about Falcon Mode from: > > https://www.amazon.com/clouddrive/share/hVlzRXoJv1Jq4DJdgDcVnfmOWjARqR06eCfheWjRcSh/folder/KZakgsCMThWy3I43j2-afQ > > Then, as the README file says I did a checkout on commit > 587c3f8ebe356b558f1876414885c1b4a31294ab and applied the patch. > > $ git am 0001-wandboard-changes-for-EW-2016-demo.patch > > I compiled without errors and then I've tried to upload to the SD card, by > doing: > > $ sudo dd if=SPL of=/dev/sdb bs=1k seek=1; sync > > $ sudo dd if=u-boot.img of=/dev/sdb bs=1k seek=69; sync > > But, everytime I try to turn on the board I got this error: > > U-Boot 2016.01-rc4-26067-g0ff7f76 (Aug 08 2016 - 09:41:44 -0300) > > CPU: Freescale i.MX6Q rev1.2 at 792 MHz > Reset cause: POR > initcall sequence 178290cc failed at call 178038bd (err=394279101) > ### ERROR ### Please RESET the board ### > > I'm using wanboard quad rev: B1. > > Does anybody know how to solve this?
It was quite a while ago, but the patch sets Falcon mode, and it tries to boot the kernel. Kernel is not in filesystem, but stored at a fixed address on the SD card (0x1000). The error you reported seems when U-Boot is starting - by pressing 'c' or if no kernel is stored. I have to find back the wandboard I used to try a run... Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
